Nissan Rogue manuals

Nissan Rogue Service Manual: Service data and specifications (sds)

Nissan Rogue Service Manual / Engine / Engine Control System / Service data and specifications (sds)

Idle Speed

Condition Specification
No load* (in P or N position) 650 ± 50 rpm

*: Under the following conditions

Ignition Timing

Condition Specification
No load* (in P or N position) 10 ± 2° BTDC

*: Under the following conditions

Calculated Load Value

Condition Specification (Using CONSULT or GST)
At idle 10 – 35 %
At 2,500 rpm 10 – 35 %

Mass Air Flow Sensor

Supply voltage Battery voltage (11 – 14 V)
Output voltage at idle 1.3 – 1.6 V*
Mass air flow (Using CONSULT or GST) 1.0 – 4.0 g/s at idle*
4.0 – 10.0 g/s at 2,500 rpm*

*: Engine is warmed up to normal operating temperature and running under no load.

Removal and installation
ECM Removal and Installation EXPLODED VIEW 1 ECM bracket 2 ECM : Vehicle front CAUTION: Perform ADDITIONAL SERVICE WHEN REPLACING ECM. Refer to EC-136, "Work Procedure". REMO ...

Fuel System
...

Other materials:

ID registration procedure
Description This procedure must be performed after replacement of a tire pressure sensor or BCM. Work Procedure TPMS ID registration can be performed using one of the following procedures:  Transmitter Activation tool [KV48105501 (J-45295-A)] with CONSULT (preferred method)   ...

Standardized relay
Description NORMAL OPEN, NORMAL CLOSED AND MIXED TYPE RELAYS Relays can mainly be divided into three types: normal open, normal closed and mixed type relays. TYPE OF STANDARDIZED RELAYS ...

Inspection and adjustment
ADDITIONAL SERVICE WHEN REMOVING BATTERY NEGATIVE TERMINAL ADDITIONAL SERVICE WHEN REMOVING BATTERY NEGATIVE TERMINAL : Description If any of the following work has been done Initial setting is necessary.  Power supply to the main power window and door lock/unlock switch or power windo ...

© 2014-2026 Copyright t32.nirogue.com