Nissan Rogue Service Manual: Rear wiper motor circuit
Component Function Check
1. CHECK REAR WIPER ON OPERATION
CONSULT ACTIVE TEST
- Select "RR WIPER" of BCM active test item.
- While operating the test item, check rear wiper operation.
ON : Rear wiper ON operation
OFF : Stop the rear wiper.
Is rear wiper operation normal? YES >> Rear wiper motor circuit is normal.
NO >> Refer to WW-47, "Diagnosis Procedure".
Diagnosis Procedure
Regarding Wiring Diagram information, refer to WW-28, "Wiring Diagram".
1. CHECK REAR WIPER MOTOR OUTPUT VOLTAGE
CONSULT ACTIVE TEST
- Turn the ignition switch OFF.
- Disconnect rear wiper motor.
- Turn the ignition switch ON.
- Select RR WIPER of BCM active test item.
- While operating the test item, check voltage between BCM harness connector and ground.
Is the inspection result normal? YES >> GO TO 2.
NO >> GO TO 3.
2. CHECK REAR WIPER MOTOR GROUND CIRCUIT
- Turn the ignition switch OFF.
- Check continuity between rear wiper motor harness connector and ground.
Is the inspection result normal? YES >> Replace rear wiper motor. Refer to WW-71, "Removal and Installation".
NO >> Repair or replace harness.
3. CHECK REAR WIPER MOTOR OPEN CIRCUIT
Check continuity between BCM harness connector and rear wiper motor harness connector.
Is the inspection result normal? YES >> GO TO 4.
NO >> Repair or replace harness.
4. CHECK REAR WIPER MOTOR SHORT CIRCUIT
Check continuity between BCM harness connector and ground.
Is the inspection result normal? YES >> Repair or replace harness.
NO >> Replace BCM. Refer to BCS-75, "Removal and Installation" (with Intelligent Key system) or BCS- 135, "Removal and Installation" (without Intelligent Key system).
Washer switch
Description
Washer switch is integrated with the combination switch.
Combination switch (wiper and washer switch) switches polarity
between front washer operating and rear
washer oper ...
Rear wiper auto stop signal circuit
Component Function Check
1. CHECK REAR WIPER (AUTO STOP) OPERATION
CONSULT DATA MONITOR
Select WIPER of BCM data monitor item.
Operate the rear wiper.
Check that RR WIPER ...
Other materials:
Diagnosis system (BCM) (without intelligent key system)
COMMON ITEM
COMMON ITEM : CONSULT Function (BCM - COMMON ITEM)
APPLICATION ITEM
CONSULT performs the following functions via CAN communication with BCM.
SYSTEM APPLICATION
BCM can perform the following functions.
BUZZER
BUZZER : CONSULT Function (BCM - BUZZER)
DATA MONITOR
ACTIV ...
Service data and specifications (SDS)
General Specification
GENERAL SPECIFICATIONS
( ): Valve timing control “ON”
Drive belt
Spark Plug
Intake Manifold
Exhaust Manifold
Camshaft
*1: Cam wear limit
*2: Total indicator reading
VALVE LIFTER
VALVE CLEARANCE
*: Approximately 80°C (176°F)
AVAIL ...
Door mirror remote control switch
Removal and Installation
REMOVAL
Release pawls using a suitable tool and remove front door pull handle
(LH). Refer to INT-15, "Exploded
View".
Release pawls (B) using a suitable tool and remove door mirror
remote control switch (1).
Remove screws (A) and d ...
