Special Service Tool
The actual shape of the tools may differ from those illustrated here.
| Tool number (TechMate No.) Tool name | Description | |
| KV38100500 ( — ) Drift |
|
Installing sensor rotor a: 80 mm (3.15 in) dia. b: 60 mm (2.36 in) dia. |
| KV40101840 ( — ) Collar |
|
Installing sensor rotor a: 67 mm (2.64 in) dia. b: 85 mm (3.35 in) dia. |
Commercial Service Tool
|
Tool name |
Description |
|
| Ball joint remover |
|
Removing wheel stud |
| Power tools |
|
Loosening nuts, screws, and bolts |
| Drive shaft puller |
|
Removing drive shaft joint sub assembly |
| Sliding hammer |
|
Removing drive shaft |
| Replacer |
|
Removing sensor rotor |
| Puller |
|
Removing sensor rotor |
Precaution
Symptom diagnosisDiagnosis system (TCM)
DIAGNOSIS DESCRIPTION
DIAGNOSIS DESCRIPTION : 1 Trip Detection Diagnosis and 2 Trip Detection
Diagnosis
NOTE:
“Start the engine and turn OFF the ignition switch after warm-up.” This is
defined as 1 trip.
1 TRIP DETECTION DIAGNOSIS
When initial malfunction is detected, TCM memorizes DTC. ...
Battery terminal with fusible link
Exploded View
Cover
Fusible link box (battery)
Positive cable
Battery
Harness connector
Front
Removal and Installation
REMOVAL
Loosen battery terminal nuts and disconnect both negative and
positive terminals from the battery.
CAUTION:
To prevent ...
Luggage hooks
When securing items using luggage hooks located
on the back of the seat or side finisher do
not apply a load over more than 6.5 lbs (29 N) to
a single hook.
The luggage hooks that are located on the floor
should have loads less than 110 lbs (490 N) to a
single hook.
The luggage hooks ...