Nissan Rogue manuals

Nissan Rogue Service Manual: Power supply and ground circuit

WITH INTELLIGENT KEY SYSTEM

WITH INTELLIGENT KEY SYSTEM : Diagnosis Procedure

Regarding Wiring Diagram information, refer to BCS-50, "Wiring Diagram".

1. CHECK FUSE

Check that the following fuse is not blown.

Terminal No. Signal name Fuse No.
161 BCM power supply 7 (10A)

Is the fuse blown? YES >> Replace the blown fuse after repairing the affected circuit.

NO >> GO TO 2.

2. CHECK POWER SUPPLY CIRCUIT

  1.  Disconnect BCM connector M20.
  2.  Check voltage between BCM connector M20 and ground.
BCM Ground Voltage (Approx.)
Connector Terminal
M20 161 — Battery voltage

Is the inspection result normal? YES >> GO TO 3.

NO >> Repair or replace harness or connectors.

3. CHECK GROUND CIRCUIT

Check continuity between BCM connector M20 and ground.

BCM Ground Continuity
Connector Terminal
M20 170 — Yes
171

Is the inspection result normal? YES >> Inspection End.

NO >> Repair or replace harness or connectors.

WITHOUT INTELLIGENT KEY SYSTEM

WITHOUT INTELLIGENT KEY SYSTEM : Diagnosis Procedure

Regarding Wiring Diagram information, refer to BCS-110, "Wiring Diagram".

1. CHECK FUSE

Check that the following fuse is not blown.

Terminal No. Signal name Fuse No.
161 BCM power supply 7 (10A)

Is the fuse blown? YES >> Replace the blown fuse after repairing the affected circuit.

NO >> GO TO 2.

2. CHECK POWER SUPPLY CIRCUIT

  1.  Disconnect BCM connector M20.
  2.  Check voltage between BCM connector M20 and ground.
BCM Ground Voltage (Approx.)
Connector Terminal
M20 161 — Battery voltage

Is the inspection result normal? YES >> GO TO 3.

NO >> Repair or replace harness or connectors.

3. CHECK GROUND CIRCUIT

Check continuity between BCM connector M20 and ground.

BCM Ground Continuity
Connector Terminal
M20 170 — Yes
171

Is the inspection result normal? YES >> Inspection End.

NO >> Repair or replace harness or connectors.

Low tire pressure warning lamp
Component Function Check 1.CHECK THE ILLUMINATION OF THE LOW TIRE PRESSURE WARNING LAMP Check that the low tire pressure warning lamp is turned OFF after illuminating for approximately 1 second, ...

Symptom diagnosis
...

Other materials:

Event Data Recorders (EDR)
This vehicle is equipped with an Event Data Recorder (EDR). The main purpose of an EDR is to record, in certain crash or near crash-like situations, such as an air bag deployment or hitting a road obstacle, data that will assist in understanding how a vehicle’s systems performed. The EDR is ...

Front wiper auto stop signal circuit
Component Function Check 1. CHECK FRONT WIPER (AUTO STOP) SIGNAL  Select FR WIPER STOP of BCM (WIPER) data monitor item.  Operate the front wiper.  Check that FR WIPER STOP changes from ON to OFF according to the wiper position Is the inspection result normal? YES ...

Settings
The setting mode allows you to change the information displayed in the vehicle information display:  Driver Assistance  Clock  Meter Settings  Vehicle Settings  Maintenance  Alarm  Tire Pressure  Unit  Language  Factory Reset ...

© 2014-2026 Copyright t32.nirogue.com