Nissan Rogue Service Manual: Low tire pressure warning lamp
Component Function Check
1.CHECK THE ILLUMINATION OF THE LOW TIRE PRESSURE WARNING LAMP
Check that the low tire pressure warning lamp is turned OFF after illuminating for approximately 1 second, when the ignition switch is turned ON.
Is the inspection result normal? YES >> Inspection End.
NO >> Perform trouble diagnosis. Refer to WT-43, "Diagnosis Procedure".
Diagnosis Procedure
1.PERFORM SELF DIAGNOSTIC RESULT
With CONSULT
- Turn the ignition switch ON.
- Perform “SELF DIAGNOSTIC RESULT”.
Are any DTCs detected? YES >> Refer to BCS-48, "DTC Index" (with Intelligent Key System) or BCS-108, "DTC Index" (without Intelligent Key System).
NO >> GO TO 2.
2.CHECK LOW TIRE PRESSURE WARNING LAMP SIGNAL
With CONSULT
- Turn the ignition switch ON.
- On “DATA MONITOR” select “WARNING LAMP.”
- Check that the low tire pressure warning lamp is turned OFF after illuminating for approximately 1 second, when the ignition switch is turned ON.
Is the inspection result normal? YES >> Check the combination meter. Refer to MWI-21, "CONSULT Function (METER/M&A)".
NO >> Replace the BCM. Refer to BCS-75, "Removal and Installation" (with Intelligent Key System) or BCS-135, "Removal and Installation" (without Intelligent Key System).
U1010 control unit (CAN)
DTC Logic
DTC DETECTION LOGIC
DTC
Display Item
Malfunction Detected Condition
Possible cause
U1010
CONTROL UNIT (CAN)
BCM detected internal CAN communication circuit m ...
Power supply and ground circuit
WITH INTELLIGENT KEY SYSTEM
WITH INTELLIGENT KEY SYSTEM : Diagnosis Procedure
Regarding Wiring Diagram information, refer to BCS-50, "Wiring Diagram".
1. CHECK FUSE
Check that the follow ...
Other materials:
Removal and installation
AV CONTROL UNIT
Exploded View
AV control unit bracket (LH)
AV control unit
AV control unit bracket (RH)
Removal and Installation
REMOVAL
CAUTION:
Before disconnecting the AV control unit and battery terminals,
turn the ignition switch OFF and wait
at least 30 secon ...
Upper link
Exploded View
Rear suspension member
Upper link
Rubber washer (LH/RH)
Rear suspension arm
Front
Removal and Installation
REMOVAL
Remove wheel and tire using power tool. Refer to WT-60, "Exploded
View"
Remove rear wheel sensor and harn ...
Wind deflector
Removal and Installation
REMOVAL
Remove headlining Refer to INT-30, "Removal and Installation".
Open the glass lid to view the wind deflector.
Use suitable tool (A) release pawl on LH/RH side of wind deflector.
: Pawl
Release wind deflector retainer (1) ...
