Nissan Rogue Service Manual: Periodic maintenance

Nissan Rogue Service Manual / Transmission & driveline / Front Axle / FWD / Periodic maintenance

FRONT WHEEL HUB AND KNUCKLE

Inspection

Move the wheel hub and bearing in an axial direction by hand to verify that looseness of wheel hub and bearing exists. If any looseness exists, replace the wheel hub and bearing.

Axial end play : Refer to FAX-32, "Wheel Bearing".

Rotate wheel hub and bearing to verify if unusual noises or other irregular conditions exist. If any irregular conditions exist, replace the wheel hub and bearing.

FRONT DRIVE SHAFT

Inspection

Check the following items and replace parts as necessary:

Check drive shaft mounting point and joint for looseness and other damage.
Check boot for cracks and other damage.

CAUTION: Replace entire drive shaft when noise or vibration occurs from drive shaft.

Symptom diagnosis

NOISE, VIBRATION AND HARSHNESS (NVH) TROUBLESHOO NVH Troubleshooting Chart Use chart below to find the cause of the symptom. If necessary, repair or replace these parts. ×: Applicable ...

Removal and installation

FRONT WHEEL HUB Exploded View Disc brake rotor Nut retainer Cotter pin Wheel stud Steering knuckle Splash guard Wheel hub and bearing Wheel hub lock n ...

Other materials:

Active trace control
This system senses driving based on the driver’s steering and acceleration/braking patterns, and controls brake pressure at individual wheels to aid tracing at corners and help smooth vehicle response. The Active Trace Control can be set to ON (enabled) or OFF (disabled) through the Vehicl ...

Periodic maintenance
IDLE SPEED Inspection 1.CHECK IDLE SPEED With CONSULT Check idle speed in “DATA MONITOR” mode of “ENGINE” using CONSULT. With GST Check idle speed with Service $01 of GST. >> INSPECTION END IGNITION TIMING Inspection 1.CHECK IGNITION TIMING Attach timing light (A) to th ...

Symptom diagnosis
POWER DOOR LOCK SYSTEM SYMPTOMS Symptom Table DOOR LOCK/UNLOCK FUNCTION MALFUNCTION NOTE: Before performing the diagnosis in the following table, check “WORK FLOW”. Refer to DLK-312, "Work Flow". Check that vehicle is under the condition shown in “Conditions ...