Nissan Rogue Service Manual: P155D generator

Nissan Rogue Service Manual / Engine / Engine Control System / DTC/Circuit diagnosis / P155D generator

DTC Description

DTC DETECTION LOGIC

DTC No.	CONSULT screen terms (Trouble diagnosis content)	DTC detecting condition
P155D	GENERATOR (Generator)	ECM receives mechanical malfunction signal sent from generator. ECM receives electrical malfunction signal sent from generator.

POSSIBLE CAUSE

Generator

FAIL-SAFE

Not applicable

DTC CONFIRMATION PROCEDURE

1.PRECONDITIONING

If DTC Confirmation Procedure has been previously conducted. always perform the following procedure before conducting the next test.

Turn ignition switch OFF and wait at least 10 seconds.
Turn ignition switch ON.
Turn ignition switch OFF and wait at least 10 seconds.

>> GO TO 2.

2.PERFORM DTC CONFIRMATION PROCEDURE

Start the engine and let it idle at least 10 seconds.
Check DTC.

Is DTC detected? YES >> Proceed to EC-175, "Diagnosis Procedure".

NO >> INSPECTION END

Diagnosis Procedure

1.CHECK CHARGING SYSTEM

Perform trouble diagnosis for charging system. Refer to EC-165, "Diagnosis Procedure".

Is the inspection result normal? YES >> GO TO 2.

NO >> Repair or replace error-detected parts.

2.CHECK INTERMITTENT INCIDENT

Check intermittent incident. Refer to GI-41, "Intermittent Incident".

Is the inspection result normal? YES >> Replace generator. Refer to CHG-20, "Removal and Installation".

NO >> Repair or replace error-detected parts.

P1226 TP sensor

DTC Description DTC DETECTION LOGIC DTC No. CONSULT screen terms (Trouble diagnosis content) DTC detecting condition P1226 CTP LEARNING-B1 (CTP LEARNING-B1) Closed ...

1564 ASCD steering switch

DTC Description DTC DETECTION LOGIC DTC No. CONSULT screen terms (Trouble diagnosis content) DTC detecting condition P1564 ASCD SW (ASCD switch) An excessi ...

Other materials:

Changing engine oil
Changing engine oil Park the vehicle on a level surface and apply the parking brake. Start the engine and let it idle until it reaches operating temperature, then turn it off. Remove the oil filler cap B by turning it counterclockwise. Place a large drain pan u ...

Basic inspection
DIAGNOSIS AND REPAIR WORK FLO Work Flow OVERALL SEQUENCE DETAILED FLOW 1.GET INFORMATION FOR SYMPTOM Get detailed information from the customer about the symptom (the condition and the environment when the incident/malfunction occurs). Check operation condition of the ...

How to erase permanent DTC
Description OUTLINE When a DTC is stored in ECM When a DTC is stored in ECM and MIL is ON, a permanent DTC is erased with MIL shutoff if the same malfunction is not detected after performing the driving pattern for MIL shutoff three times in a raw. *1: When the same malfunction is detecte ...