Nissan Rogue Service Manual: Mixture ratio self-learning value clear

Nissan Rogue Service Manual / Engine / Engine Control System / Basic inspection / Mixture ratio self-learning value clear

Description

This describes how to erase the mixture ratio self-learning value. For the actual procedure, follow the instructions in “Diagnosis Procedure”.

Work Procedure

1.START

With CONSULT

Start engine and warm it up to normal operating temperature.
Select “SELF-LEARNING CONT” in “WORK SUPPORT” mode of “ENGINE” using CONSULT.
Clear mixture ratio self-learning value by touching “CLEAR”.

With GST

Start engine and warm it up to normal operating temperature.
Turn ignition switch OFF.
Disconnect mass air flow sensor harness connector.
Restart engine and let it idle for at least 5 seconds.
Stop engine and reconnect mass air flow sensor harness connector.
Select Service $03 with GST. Make sure DTC P0102 is detected.
Select Service $04 with GST to erase the DTC P0102.

>> END

Idle air volume learning

Description Idle Air Volume Learning is a function of ECM to learn the idle air volume that keeps each engine idle speed within the specific range. It must be performed under any of the following ...

Fuel pressure

Work Procedure FUEL PRESSURE RELEASE 1.FUEL PRESSURE RELEASE With CONSULT Turn ignition switch ON. Perform “FUEL PRESSURE RELEASE” in “WORK SUPPORT” mode of “ENGINE” ...

Other materials:

P1572 brake pedal position switch
DTC Description DTC DETECTION LOGIC NOTE: This self-diagnosis has the one trip detection logic. When malfunction A is detected, DTC is not stored in ECM memory. And in that case, 1st trip DTC and 1st trip freeze frame data are displayed. 1st trip DTC is erased when ignition switch OFF. And ...

Symptom diagnosis
SQUEAK AND RATTLE TROUBLE DIAGNOSES Work Flow CUSTOMER INTERVIEW Interview the customer if possible, to determine the conditions that exist when the noise occurs. Use the Diagnostic Worksheet during the interview to document the facts and conditions when the noise occurs and any custome ...

Rear regulator
Exploded View Rear door panel Rear door glass corner finisher Rear door glass rear run channel Rear door regulator assembly Rear door glass power window motor Rear door glass Rear door glass rubber run channel Removal and Installation REMOVAL Remove the re ...