Nissan Rogue manuals

Nissan Rogue Service Manual: Anti-pinch function does not operate

MOONROOF

MOONROOF : Diagnosis Procedure

1. PERFORM INITIALIZATION PROCEDURE

Perform initialization procedure.

Refer to RF-24, "ADDITIONAL SERVICE WHEN REPLACING CONTROL UNIT : Special Repair Requirement".

Is the inspection result normal? YES >> GO TO 2.

NO >> Perform basic inspection. Refer to RF-22, "Work Flow".

2.RETEST THE ANTI-PINCH FUNCTION

Check anti-pinch operation. Refer to RF-24, "ADDITIONAL SERVICE WHEN REPLACING CONTROL UNIT : Special Repair Requirement".

Is the inspection result normal? YES >> Inspection End.

NO >> Replace the moonroof motor assembly. Refer to RF-53, "Removal and Installation".

SUNSHADE

SUNSHADE : Diagnosis Procedure

1.CHECK SUNSHADE MECHANISM

Check the following:

Is the inspection result normal? YES >> GO TO 2.

NO >> Repair or replace the malfunctioning parts.

2. PERFORM INITILAZATION PROCEDURE

Perform anti-pinch procedure.

Refer to RF-24, "ADDITIONAL SERVICE WHEN REPLACING CONTROL UNIT : Special Repair Requirement".

Is the inspection result normal? YES >> GO TO 3.

NO >> GO TO 1.

3.RETEST THE ANTI-PINCH FUNCTION

Check anti-pinch operation. Refer toRF-24, "ADDITIONAL SERVICE WHEN REPLACING CONTROL UNIT : Special Repair Requirement".

Is the inspection result normal? YES >> Inspection End.

NO >> Replace the sunshade motor assembly. Refer to RF-62, "Removal and Installation".

Auto operation does not operate
MOONROOF MOONROOF : Diagnosis Procedure 1. PERFORM INITIALIZATION PROCEDURE Perform initialization procedure. Refer to RF-24, "ADDITIONAL SERVICE WHEN REPLACING CONTROL UNIT : Special Repai ...

Retained power operation does not operate properly
Diagnosis Procedure 1.CHECK FRONT DOOR SWITCH Check (LH and RH) front door switches. Refer to DLK-24, "Front Door Switch". Is the inspection result normal? YES >> GO TO 2. ...

Other materials:

Precaution
Precaution for Supplemental Restraint System (SRS) "AIR BAG" and "SEAT BELT PRE-TENSIONER" The Supplemental Restraint System such as “AIR BAG” and “SEAT BELT PRE-TENSIONER”, used along with a front seat belt, helps to reduce the risk or severity of injury to the ...

P0137 HO2S2
DTC Description DTC DETECTION LOGIC The heated oxygen sensor 2 has a much longer switching time between rich and lean than the air fuel ratio (A/F) sensor 1. The oxygen storage capacity of the three way catalyst (manifold) causes the longer switching time. To judge the malfunctions of heated ox ...

Crash zone sensor
Exploded View Crash zone sensor  Crash zone sensor harness connector  Bracket Removal and Installation WARNING:  Before servicing the SRS, turn ignition switch OFF, disconnect both battery terminals then wait at least three minutes.  Do not use a ...

© 2014-2026 Copyright t32.nirogue.com