Nissan Rogue Owners Manual: Air cleaner

Nissan Rogue Owners Manual / Maintenance and do-it-yourself / Air cleaner

Air cleaner

The air cleaner filter should not be cleaned and reused. Replace it according to the maintenance log shown in the “NISSAN Service and Maintenance Guide.” To remove the air cleaner filter:

Unlatch the retaining clips A .
Pull up at points B and remove.
Pull up and remove air cleaner housing C .
Remove the air cleaner filter. Wipe the inside of the air cleaner filter housing and the cover with a damp cloth, then replace air cleaner filter.

NOTE: After installing a new air cleaner, make sure the air cleaner cover is seated in the housing and latch the clips.

WARNING

Operating the engine with the air cleaner removed can cause you or others to be burned. The air cleaner not only cleans the air, it stops the flame if the engine backfires. If it isn’t there, and the engine backfires, you could be burned. Do not drive with the air cleaner removed, and be careful when working on the engine with the air cleaner removed.
Never pour fuel into the throttle body or attempt to start the engine with the air cleaner removed. Doing so could result in serious injury.

IN-CABIN MICROFILTER

The in-cabin microfilter restricts the entry of airborne dust and pollen particles and reduces some objectionable outside odors. The filter is located behind the glove box. Refer to the “NISSAN Service and Maintenance Guide” for change intervals.

If replacement is required, see your NISSAN dealer.

Spark plugs

Replacing spark plugs Platinum-tipped spark plugs It is not necessary to replace platinum-tipped A spark plugs as frequently as conventional type spark plugs because they last much longer. Fol ...

Windshield wiper blades

Cleaning If your windshield is not clear after using the windshield-washer or if a wiper blade chatters when running, wax or other material may be on the blade or windshield. Clean the outside ...

Other materials:

Unit removal and installation
REAR FINAL DRIVE ASSEMBLY Exploded View Final drive mounting bracket Mounting stopper Rear final drive assembly : N·m (kg-m, ft-lb) : Always replace after every disassembly. Removal and Installation REMOVAL Remove rear propeller shaft. Refer to DLN-99, "Explode ...

Front wiper motor
Removal and Installation REMOVAL Remove the front drive assembly. Refer to WW-66, "Removal and Installation". Remove the bolts (A) from the front wiper drive assembly (1) and the front wiper motor (2). Separate the wiper motor (1) from the front wiper drive ...

Vehicle information
Identification information Model Variation FWD Model AWD Model Prefix and Suffix Designations Identification Number Air conditioner specification label Emission control information label Vehicle identification number chassis number (center of bulkhead) ...