![]() |
Anti-lock Braking System (ABS) warning light |
![]() |
Brake warning light |
![]() |
Charge warning light |
![]() |
Low tire pressure warning light |
![]() |
Low windshield washer fluid warning light (if so equipped) |
![]() |
Master warning light |
![]() |
Power steering warning light |
![]() |
Seat belt warning light and chime |
![]() |
Supplemental air bag warning light |
![]() |
All-Wheel Drive (AWD) AUTO indicator light (if so equipped) |
![]() |
All-Wheel Drive (AWD) LOCK indicator light (if so equipped) |
![]() |
ECO Mode indicator light |
![]() |
Front fog light indicator light (if so equipped) |
![]() |
Front passenger air bag status light |
![]() |
High beam indicator light (blue) |
![]() |
Hill descent indicator light (if so equipped) |
![]() |
Malfunction Indicator Light (MIL) |
![]() |
Overdrive off indicator light |
![]() |
Security indicator light |
![]() |
Slip indicator light |
![]() |
Sport mode indicator light |
![]() |
Turn signal/hazard indicator lights |
![]() |
Vehicle Dynamic Control (VDC) off indicator light |
Checking bulbs
With all doors closed, apply the parking brake and place the ignition switch to the ON position without starting the engine. The following lights will come on:
, or
,
,
,

The following lights come on briefly and then go off:
,
,
,
,
,

If any light fails to come on, it may indicate a burned-out bulb or an open circuit in the electrical system. Have the system repaired promptly.
Fuel gauge
Warning lightsPeriodic maintenance
IN-CABIN MICROFILTER
Removal and Installation
REMOVAL
Release the tab and remove the in-cabin microfilter cover (1)
from under the RH side of the instrument panel.
CAUTION:
Use care when lifting up on the tab to avoid damaging it.
Remove the in-cabin microfilter (2).
CAUT ...
Available views
WARNING
The distance guide line and the vehicle
width line should be used as a reference
only when the vehicle is on a paved,
level surface. The distance viewed on
the monitor may be different than the
actual distance between the vehicle and
displayed objects ...
Malfunction indicator lamp
Component Function Check
1.CHECK MIL FUNCTION
Turn ignition switch ON.
Check that MIL illuminates.
Is the inspection result normal?
YES >> INSPECTION END
NO >> Proceed to EC-476, "Diagnosis Procedure".
Diagnosis Procedure
1.CHECK DTC
Check that DTC UX ...