Nissan Rogue manuals

Nissan Rogue Owners Manual: Seats

Seats

WARNING
  •  Do not ride in a moving vehicle when the seatback is reclined. This can be dangerous. The shoulder belt will not be against your body. In an accident, you could be thrown into it and receive neck or other serious injuries. You could also slide under the lap belt and receive serious internal injuries.
  •  For the most effective protection when the vehicle is in motion, the seat should be upright. Always sit well back in the seat with both feet on the floor and adjust the seat properly. For additional information, refer to “Precautions on seat belt usageâ€� in this section.
  •  After adjustment, gently rock in the seat to make sure it is securely locked.
  •  Do not leave children unattended inside the vehicle. They could unknowingly activate switches or controls. Unattended children could become involved in serious accidents.
  •  Do not adjust the driver’s seat while driving so full attention may be given to vehicle operation. The seat may move suddenly and could cause loss of control of the vehicle.
  •  The seatback should not be reclined any more than needed for comfort. Seat belts are most effective when the passenger sits well back and straight up in the seat. If the seatback is reclined, the risk of sliding under the lap belt and being injured is increased.

 

CAUTION

When adjusting the seat positions, be sure not to contact any moving parts to avoid possible injuries and/or damage.

Safety—Seats, seat belts and supplemental restraint system
...

Front manual seat adjustment (if so equipped)
Forward and backward Pull the center of the bar up and hold it while you slide the seat forward or backward to the desired position. Release the bar to lock the seat in position. Reclining ...

Other materials:

C1606 EPS motor
DTC Logic DTC DETECTION LOGIC DTC Display item Malfunction detected condition Possible cause C1606 EPS MOTOR When the motor driver malfunction of EPS control unit or EPS motor malfunction is detected. Harness or connector  EPS ...

The ambient temperature display is incorrect
Description The displayed outside air temperature is higher than the actual temperature.  The displayed outside air temperature is lower than the actual temperature.  Outside air temperature is not indicated. Diagnosis Procedure 1.CHECK AMBIENT SENSOR SIGNAL CIRCUIT Chec ...

Wheel and tire
Adjustment BALANCING WHEELS (ADHESIVE WEIGHT TYPE) Preparation Before Adjustment Remove inner and outer balance weights from the wheel. Using releasing agent, remove double-faced adhesive tape from the wheel and tire. CAUTION:  Be careful not to scratch the wheel and tire during remo ...

© 2014-2026 Copyright t32.nirogue.com