Nissan Rogue Service Manual: Preparation

Nissan Rogue Service Manual / Steering / Steering System / Preparation

Special Service Tools

The actual shape of the tools may differ from those illustrated here.

Tool number (TechMate No.) Tool name		Description
— (J-44372) Pull gauge		Measuring steering wheel turning force, rack sliding force and ball joint swinging force
KV40107300 ( — ) Boot Band crimping tool		Installing boot bands (large diameter)

Commercial Service Tools

Tool name		Description
Steering wheel puller		Removing steering wheel
Ball joint remover		Removing ball joint
ST3127S000 (J-25765-A) Preload gauge 1. GG9103000 (J-25765-A) Torque wrench 2. HT62940000 ( – ) Socket adapter 3. HT62900000 ( – ) Socket adapter		Inspecting of rotating torque for ball joint and steering column
Power tool		Loosening nuts, screws and bolts

Precaution

Precaution for Supplemental Restraint System (SRS) "AIR BAG" and "SEAT BELT PRE-TENSIONER" The Supplemental Restraint System such as “AIR BAG” and “SEAT BELT PRE-TENSIONE ...

Symptom diagnosis

NOISE, VIBRATION AND HARSHNESS (NVH) TROUBLESHOOTING NVH Troubleshooting Chart Use the chart below to find the cause of the symptom. If necessary, repair or replace these parts. ×: Applicabl ...

Other materials:

U1001 CAN comm circuit
Description CAN (Controller Area Network) is a serial communication line for real time application. It is an on-vehicle multiplex communication line with high data communication speed and excellent error detection ability. Many electronic control units are equipped onto a vehicle, and each co ...

SRS air bag warning lamp does not turn on
AIR BAG Warning Lamp Does Not Turn On 1.CHECK METER FUSE Check the 10A fuse [No. 13, located in the fuse block (J/B)]. Is the fuse blown? YES >> GO TO 2. NO >> GO TO 3. 2.REPLACE METER FUSE AND CHECK AGAIN Replace 10A fuse [No. 13, located in the fuse block (J/B)] and turn ign ...

Cylinder head
Exploded View Cylinder head Cylinder head gasket Refer to INSTALLATION Removal and Installation REMOVAL Remove the timing chain. Refer to EM-45, "Removal and Installation". Remove the camshafts. Refer to EM-64, "Exploded View". & ...