Nissan Rogue Service Manual: Preparation

Location of plastic parts

Precautions for Plastics CAUTION:  When repairing and painting a portion of the body adjacent to plastic parts, consider their characteristics (influence of heat and solvent) and re ...

Repairing material

Foam Repair During factory body assembly, foam insulators are installed in certain body panels and locations around the vehicle. Use the following procedure(s) to replace any factory-installed foa ...

Other materials:

Front power seat adjustment (if so equipped)
Operating tips  The power seat motor has an auto-reset overload protection circuit. If the motor stops during operation, wait 30 seconds then reactivate the switch.  Do not operate the power seat switch for a long period of time when the engine is off. This will dischar ...

Front wiper drive assembly
Exploded View REMOVAL Cowl top Front wiper drive assembly Removal and Installation REMOVAL  Remove cowl top cover. Refer to EXT-25, "Removal and Installation".  Disconnect harness connector from front wiper motor.  Remove bolts and front wiper driv ...

Precaution
Precaution for supplemental restraint system (srs) "air bag" and "seat belt pre-tensioner" The Supplemental Restraint System such as “AIR BAG” and “SEAT BELT PRE-TENSIONER”, used along with a front seat belt, helps to reduce the risk or severity of injury to the ...