Nissan Rogue Service Manual: Preparation

Nissan Rogue Service Manual / Body exterior, doors, roof & vehicle security / Door & Lock / With intelligent key system / Preparation

Special Service Tool

The actual shapes of the tools may differ from those illustrated here.

Tool number (TechMate No.) Tool name		Description
— (J-39570) Chassis Ear		Locating the noise
— (J-50397) NISSAN Squeak and Rattle Kit		Repairing the cause of noise
— (J-43241) Remote Keyless Entry Tester		Used to test keyfobs
— (J-50190) Signal Tech II		Activate and display TPMS transmitter IDs Display tire pressure reported by the TPMS transmitter Read TPMS DTCs Register TPMS transmitter IDs Check Intelligent Key relative signal strength Confirm vehicle Intelligent Key antenna signal strength Compatible with future sensors Equipped with a display
KV48105501 (J-45295-A) Transmitter Activation Tool		Activate TPMS transmitter IDs Compatible with future sensors Equipped with a display (KV48105501 only)
— (J-46534) Trim Tool Set		Removing trim components

Commercial Service Tool

(TechMate No.) Tool name		Description
(J-39565) Engine Ear		Locating the noise
( — ) Power Tool		Loosening nuts, screws and bolts

Precaution

Precaution for Supplemental Restraint System (SRS) "AIR BAG" and "SEAT BELT PRE-TENSIONER" The Supplemental Restraint System such as “AIR BAG” and “SEAT BELT PRE-TENSIONE ...

System description

COMPONENT PARTS POWER DOOR LOCK SYSTEM POWER DOOR LOCK SYSTEM : Component Parts Location No Component Function 1 BCM Controls the door lock system. Re ...

Other materials:

The fuel gauge does not move
Description Fuel gauge does not move from a certain position. Diagnosis Procedure 1.CONDUCTING THE COMBINATION METER SELF-DIAGNOSIS MODE Perform the self-diagnosis mode of combination meter, and then check that the fuel gauge operates normally. Refer to MWI-19, "Description". I ...

All-wheel drive (AWD) lock switch (if so equipped)
All-wheel drive (AWD) lock switch (if so equipped) The all-wheel drive (AWD) lock switch is locaton the instrument panel. The AWD LOCK indicator light will illuminate when the switch is turned on. For additional information, refer to “Warning/Indicator lights and audible reminders” in ...

CAN system (type 3)
MAIN LINE BETWEEN IPDM-E AND DLC CIRCUIT Diagnosis Procedure 1.CHECK CONNECTOR Turn the ignition switch OFF. Disconnect the battery cable from the negative terminal. Check the following terminals and connectors for damage, bend and loose connection (connector side and harn ...