Nissan Rogue Owners Manual: Parking/parking on hills

Nissan Rogue Owners Manual / Starting and driving / Parking/parking on hills

Parking/parking on hills

WARNING

Do not stop or park the vehicle over flammable materials such as dry grass, waste paper or rags. They may ignite and cause a fire.
Safe parking procedures require that both the parking brake be set and the transmission placed into P (Park). Failure to do so could cause the vehicle to move unexpectedly or roll away and result in an accident. Make sure the shift lever has been pushed as far forward as it can go and cannot be moved without depressing the foot brake pedal.
Never leave the engine running while the vehicle is unattended.
Do not leave children unattended inside the vehicle. They could unknowingly activate switches or controls. Unattended children could become involved in serious accidents.

Firmly apply the parking brake.
Move the shift lever to the P (Park) position.
To help prevent the vehicle from rolling into traffic when parked on an incline, it is a good practice to turn the wheels as illustrated.

HEADED DOWNHILL WITH CURB: A Turn the wheels into the curb and move the vehicle forward until the curb side wheel gently touches the curb.
HEADED UPHILL WITH CURB: B Turn the wheels away from the curb and move the vehicle back until the curb side wheel gently touches the curb.
HEADED UPHILL OR DOWNHILL, NO CURB: C Turn the wheels toward the side of the road so the vehicle will move away from the center of the road if it moves.

Place the ignition switch in the LOCK position.

Intelligent 4WD (if so equipped)

4X4–I SYSTEM OPERATION WARNING Do not drive beyond the performance capability of the tires. Accelerating quickly, sharp steering maneuvers or sudden braking may cause l ...

Power steering

WARNING If the engine is not running or is turned off while driving, the power assist for the steering will not work. Steering will be harder to operate. When th ...

Other materials:

DTC/circuit diagnosis
U1000 CAN COMM CIRCUIT Description Refer to LAN-8, "System Description". DTC Logic DTC DETECTION LOGIC NOTE: U1000 can be set if a module harness was disconnected and reconnected, perhaps during a repair. Confirm that there are actual CAN diagnostic symptoms and a present DTC by p ...

Outside mirrors
Outside mirrors The outside mirror remote control will operate only when the ignition switch is in the ACC or ON position. Move the small switch 1 to select the right or left mirror. Adjust each mirror to the desired position using the large switch 2 . WARNING Objects v ...

C1735 ignition signal
DTC Logic NOTE: The Signal Tech II Tool [- (J-50190)] can be used to perform the following functions. Refer to the Signal Tech II User Guide for additional information. Activate and display TPMS sensor IDs Display tire pressure reported by the TPMS sensor Read TPMS DTC ...