DTC Description
DTC DETECTION LOGIC
| DTC | CONSULT screen terms (Trouble diagnosis content) | DTC detection condition |
| P0841 | FLUID PRESS SEN/SW A (Transmission Fluid Pressure Sensor/Switch “A� Circuit Range/Performance) | When all of the following conditions are satisfied and this state is
maintained
for 5 seconds:
|
POSSIBLE CAUSE
FAIL-SAFE
Not changed from normal driving
DTC CONFIRMATION PROCEDURE
CAUTION: Always drive vehicle at a safe speed.
1.PREPARATION BEFORE WORK
If another “DTC CONFIRMATION PROCEDURE� occurs just before, turn ignition switch OFF and wait for at least 10 seconds, then perform the next test.
>> GO TO 2.
2.CHECK DTC DETECTION
Selector lever : “D� position
Vehicle speed : Constant speed of 40 km/h (25 MPH)
CAUTION: Also keep the accelerator pedal position constant.
Is “P0841� detected? YES >> Go to TM-145, "Diagnosis Procedure".
NO-1 >> To check malfunction symptom before repair: Refer to GI-41, "Intermittent Incident".
NO-2 >> Confirmation after repair: INSPECTION END
Diagnosis Procedure
1.REPLACE TRANSAXLE ASSEMBLY
Replace transaxle assembly. Refer to TM-220, "Removal and Installation".
>> WORK END
P0779 pressure control solenoid B
P0847 transmission fluid pressure SEN/SW BSymptom diagnosis
INTERIOR LIGHTING SYSTEM SYMPTOMS
Symptom Table
CAUTION:
Perform the self-diagnosis with CONSULT before the symptom diagnosis. Perform
the trouble diagnosis
if any DTC is detected.
Symptom
Possible cause
Inspection item
All the following lamps do not turn ON. ...
Ducts and grilles
Exploded View
Side defroster duct (RH)
Defroster nozzle
Side defroster duct (LH)
Center ventilator duct
Heating and cooling unit assembly
Front foot duct (LH)
Front floor connecting duct (LH)
Front floor duct (LH)
Rear center ventilator duct
Adaptor duct 11 ...
Cylinder block
Exploded View
Cylinder block
Top ring
Second ring
Oil ring
Snap ring
Piston
Connecting rod
Piston pin
Connecting rod bearing
Rear oil seal
Reinforcement plate
Drive plate
Signal plate
Pilot convert ...