Nissan Rogue Service Manual: ID registration cannot be completed
Description
The ID of the tire pressure sensor installed in each wheel cannot be registered in the tire pressure monitoring system. Inspect the tire pressure sensor or the tire pressure monitoring system circuit.
Diagnosis Procedure
1.CHECK TIRE PRESSURE SENSOR ACTIVATION TOOL
Check tire pressure sensor activation tool.
Is the inspection result normal? YES >> GO TO 2.
NO >> Replace the battery of tire pressure sensor activation tool or repair/replace the tire pressure sensor activation tool.
2.TIRE PRESSURE SENSOR ID REGISTRATION
Perform tire pressure sensor ID registration. Refer to WT-21, "Work Procedure"
CAUTION: To perform ID registration, observe the following points:
- Never register ID in a place where radio waves are interfered (e.g. radio tower).
- Never register ID in a place close to vehicles including TPMS.
Is tire pressure sensor ID registration completed? YES >> Inspection End.
NO >> GO TO 3.
3.CHECK TIRE PRESSURE SIGNAL
Change the work location and perform ID registration again.
NOTE: Depending on the tire pressure sensor position*, a blind spot exists, and the tire pressure receiver gets poor reception. If an ID registration is performed under this condition, the registration may not be completed. In such case, follow the instructions below to improve the radio wave receiving environment.
- Rotate tire by 90°, 180°, or 270°. (This Step is to change tire pressure sensor position.)
- Open the door close to the tire of which ID registration is ongoing.
*: Radio wave reception condition depends on vehicle architecture (e.g. body harness layout, tire wheel design) or environment.
When ID registration is performed, which wheels do not react? All wheels react and ID registration is possible.>>Inspection End.
Only certain wheel(s) do not react.>>Replace applicable tire pressure sensor. Refer to WT-61, "Removal and Installation".
All wheels do not react.>>Replace BCM. Refer to BCS-75, "Removal and Installation" (with Intelligent Key System) or BCS-135, "Removal and Installation" (without Intelligent Key System).
Low tire pressure warning lamp blinks
Description
The low tire pressure warning lamp blinks when the power switch is turned ON.
NOTE:
The position of an inactive tire pressure sensor can be identified by checking
the blinking timing ...
Easy fill tire alert does not activate
Description
The easy fill tire alert does not function while inflating a tire when the
select lever position is in P-range with the
power switch ON or with the vehicle set to READY.
NOTE:
&nb ...
Other materials:
Front passenger air bag module
Exploded View
Front passenger air bag module
Steering member
Removal and Installation
WARNING:
Before servicing the SRS, turn ignition switch OFF, disconnect
both battery terminals then wait at
least three minutes.
Always work from the side of air bag module. Do ...
Chassis maintenance
EXHAUST SYSTEM
EXHAUST SYSTEM : Inspection
Check exhaust pipes, muffler, and mounting for improper attachment,
leakage, cracks, damage or deterioration.
If anything is found, repair or replace damaged parts.
CVT FLUID
CVT FLUID : Inspection
FLUID LEAKAGE
Check transax ...
TPMS
Symptom Table
LOW TIRE PRESSURE WARNING LAMP SYMPTOM CHART
Diagnosis
items
Symptom
(Power switch ON)
Low tire pressure warning lamp
Cause
Action
Low tire pressure
warning
lamp
The low tire pressure
warning lamp
illuminates for 1
second, then turn ...
