Nissan Rogue manuals

Nissan Rogue Service Manual: Does not operate

Description

VDC function, TCS function, ABS function, EBD function, Brake limited slip differential (BLSD) function, Brake assist function, hill start assist function or Brake force distribution function does not operate.

Diagnosis Procedure

CAUTION:

1.CHECK ABS WARNING LAMP

Check that ABS warning lamp, brake warning lamp and VDC warning lamp turn ON and turn OFF approx. 1 second after key switch is turned ON. Check that ABS warning lamp, brake warning lamp and VDC warning lamp and stay in OFF status during driving.

CAUTION: Brake warning lamp turns ON when parking brake is operated (parking brake switch is ON) or brake fluid is less than the specified level (brake fluid level switch is ON). Is the inspection result normal? YES >> Normal NO >> GO TO 2.

2.PERFORM SELF-DIAGNOSIS

With CONSULT

  1.  Turn the ignition switch OFF → ON.

CAUTION:

  1.  Repeat step 1 two or more times.
  2.  Perform self-diagnosis for “ABS” with CONSULT.

Is any DTC detected? YES >> Check the DTC. Refer to BRC-55, "DTC Index".

NO >> Inspection End.

The braking distance is long
Description Brake stopping distance is long when ABS function is operated. Diagnosis Procedure CAUTION: Brake stopping distance on slippery road like rough road, gravel road or snowy road may be ...

Brake pedal vibration or operation sound occurs
Description Brake pedal vibrates and motor sound from ABS actuator and electric unit (control unit) occurs, when the engine starts.  Brake pedal vibrates during braking. CAUTION: V ...

Other materials:

Precaution
Precaution for Supplemental Restraint System (SRS) "AIR BAG" and "SEAT BELT PRE-TENSIONER" The Supplemental Restraint System such as “AIR BAG” and “SEAT BELT PRE-TENSIONER”, used along with a front seat belt, helps to reduce the risk or severity of injury to the ...

Normal operating condition
Description FUEL CUT CONTROL (AT NO LOAD AND HIGH ENGINE SPEED) If the engine speed is above 1,800 rpm under no load (for example, the selector lever position is neutral and engine speed is over 1,800 rpm) fuel will be cut off after some time. The exact time when the fuel is cut off varies b ...

The fuel gauge does not move
Description Fuel gauge does not move from a certain position. Diagnosis Procedure 1.CONDUCTING THE COMBINATION METER SELF-DIAGNOSIS MODE Perform the self-diagnosis mode of combination meter, and then check that the fuel gauge operates normally. Refer to MWI-19, "Description". I ...

© 2014-2026 Copyright t32.nirogue.com