Nissan Rogue Service Manual: Diagnosis and repair work flow
Work Flow
NOTE: The Signal Tech II Tool [- (J-50190)] can be used to perform the following functions. Refer to the Signal Tech II User Guide for additional information.
- Activate and display TPMS sensor IDs
- Display tire pressure reported by the TPMS sensor
- Read TPMS DTCs
- Register TPMS sensor IDs
1.COLLECT INFORMATION FROM CUSTOMER
Get detailed information from the customer about the symptom (the condition and the environment when the incident/malfunction occurred).
>> GO TO 2.
2.TIRE PRESSURE INSPECTION
Check the tire pressure for all wheels. Refer to WT-65, "Tire Air Pressure".
Is the inspection result normal? YES >> GO TO 3.
NO >> Repair or replace tire(s) or wheel(s).
3.CHECK LOW TIRE PRESSURE WARNING LAMP
Check that the low tire pressure warning lamp illuminates for approximately 1 second after the ignition switch is turned ON, then turns OFF.
Does the low tire pressure warning lamp turn OFF? YES >> Inspection End.
NO >> GO TO 4.
4.PERFORM SELF DIAGNOSTIC RESULT
Perform self diagnostic result. Refer to BCS-26, "AIR PRESSURE MONITOR : CONSULT Function (BCM-AIR PRESSURE MONITOR)" (with Intelligent Key System) or BCS-94, "AIR PRESSURE MONITOR : CONSULT Function (BCM-AIR PRESSURE MONITOR)" (without Intelligent Key System).
Are any DTCs displayed? YES >> Refer to BCS-48, "DTC Index". If two or more DTCs are displayed, refer to BCS-47, "DTC Inspection Priority Chart".
NO >> GO TO 5.
5.PERFORM DIAGNOSIS APPLICABLE TO THE SYMPTOM
Perform diagnosis applicable to the symptom. Refer to WT-46, "Symptom Table".
>> GO TO 6.
6.FINAL CHECK
Perform self diagnostic result again, and check that the malfunction is repaired. After checking, erase the self diagnosis memory. Refer to BCS-26, "AIR PRESSURE MONITOR : CONSULT Function (BCM-AIR PRESSURE MONITOR)" (with Intelligent Key System) or BCS-94, "AIR PRESSURE MONITOR : CONSULT Function (BCM-AIR PRESSURE MONITOR)" (without Intelligent Key System).
>> Inspection End.
Basic inspection
...
ID registration procedure
Description
This procedure must be performed after replacement of a tire pressure sensor
or BCM.
Work Procedure
TPMS ID registration can be performed using one of the following procedures:
&n ...
Other materials:
P0102, P0103 MAF sensor
DTC Description
DTC DETECTION LOGIC
DTC No.
CONSULT screen terms
(Trouble diagnosis content)
DTC detecting condition
P0102
MAF SEN/CIRCUIT-B1
(Mass or volume air flow ″A″ circuit low)
An excessively low voltage from the mass air flow sensor is sent to ...
Over fender
FRONT OVER FENDER
FRONT OVER FENDER : Exploded View
Front fender protector
Front fender
Front over fender molding
Clip
FRONT OVER FENDER : Removal and Installation
REMOVAL
Remove front and rear screw (A).
1: Front over fender
2: Sill molding
: Front
...
Air flow charts
The following charts show the button and dial
positions for MAXIMUM AND QUICK heating,
cooling or defrosting. The air recirculation indicator
should always be in the OFF position
for heating and defrosting.
...
