Nissan Rogue Owners Manual: Continuously Variable Transmission (CVT) fluid

Nissan Rogue Owners Manual / Maintenance and do-it-yourself / Engine oil / Continuously Variable Transmission (CVT) fluid

CAUTION

NISSAN recommends using Genuine NISSAN CVT Fluid NS-3 ONLY in NISSAN CVTs. Do not mix with other fluids.
Do not use Automatic transmission fluid (ATF) or Manual transmission fluid in a NISSAN CVT, as it may damage the CVT. Damage caused by the use of fluids other than recommended is not covered under NISSAN’s New Vehicle Limited Warranty.
Using fluids that are not equivalent to Genuine NISSAN CVT Fluid NS-3 may damage the CVT. Damage caused by the use of fluids other than as recommended is not covered under NISSAN’s New Vehicle Limited Warranty.

When checking or replacement of CVT fluid is required, we recommend your NISSAN dealer for servicing.

Changing engine oil filter

> Changing engine oil filter Park the vehicle on a level surface and apply the parking brake. Turn the engine off. Place a large drain pan under the oil filter B . Remove pins ...

Brake fluid

Brake fluid Check the brake fluid level in the reservoir. If the brake warning light comes on, add Genuine NISSAN Super Heavy Duty Brake Fluid or equivalent DOT 3 fluid up to the MAX line. If fl ...

Other materials:

Periodic maintenance
REAR DIFFERENTIAL GEAR OIL Inspection OIL LEAKS Make sure that oil is not leaking from final drive assembly or around it. OIL LEVEL Remove filler plug (1) and check oil level from filler plug mounting hole as shown. CAUTION: Do not start engine while checking oil level. &nbs ...

Performance test
Inspection INSPECTION PROCEDURE Connect recovery/recycling/recharging equipment (for HFC-134a) or manifold gauge. Start the engine, and set to the following condition. Test condition Maintain test condition until A/C system becomes stable. (Approximately 10 minute ...

U110f lost communication (ECM)
DTC Description DTC DETECTION LOGIC DTC CONSULT screen terms (Trouble diagnosis content) DTC detection condition U110F LOST COMM (ECM) (Lost Communication With ECM) When the ignition switch is ON, TCM is unable to receive the CAN communications signal from ...