Nissan Rogue (T33) 2021-Present Owner’s Manual & User Guide: Windshield wiper blades
Cleaning
Basic information
If the windshield of your Nissan Rogue remains unclear after using the washer, or if the wiper blades chatter, wax or debris may be present on the glass or the blades.
Clean the windshield with washer solution or mild detergent. A clean surface will not form water beads during rinsing.
Clean each blade by wiping it with a cloth soaked in washer solution or mild detergent, then rinse with clear water. If the windshield remains unclear afterward, replace the blades.
CAUTION
Worn wiper blades may damage the windshield and reduce visibility.
When a washer nozzle is clogged
If a washer nozzle becomes clogged or malfunctions, it is recommended to have it inspected by a NISSAN dealer. Do not attempt to clear the nozzle using a needle or pin, as this may cause damage.
Replacing
Replace the wiper blades if they are worn.
1. Lift the wiper arm away from the windshield.
2. Open A with a suitable tool, then slide the blade downward to remove it.
3. Install the new blade on the arm until a click is heard.
4. Close A.
CAUTION
- After replacing the wiper blade, return the wiper arm to its original position to avoid damage when opening the hood.
- Make sure the blades fully contact the glass to prevent wind damage to the arm.
Rear window wiper blade
For checking or replacing the rear wiper blade, it is recommended to visit a NISSAN dealer.
Air cleaner
To remove the filter on the Nissan Rogue, release the lock pins 1 and pull the unit upward 2.
The viscous paper filter element (if equipped) is not designed to be cleaned and reused. The dry p ...
Brakes
Basic information
If the brakes on your Nissan Rogue do not operate correctly, it is recommended to have the system inspected by a NISSAN dealer.
Self-adjusting brakes
The vehicle uses self-adjust ...
Other materials:
Diagnosis system (BCM) (without intelligent key system)
COMMON ITEM
COMMON ITEM : CONSULT Function (BCM - COMMON ITEM)
APPLICATION ITEM
CONSULT performs the following functions via CAN communication with BCM.
Direct Diagnostic Mode
Description
Ecu Identification
The BCM part number is displayed.
Self Diagnostic ...
P2096, P2097 A/F sensor 1
DTC Description
DTC DETECTION LOGIC
DTC No.
CONSULT screen terms
(Trouble diagnosis content)
DTC detecting condition
P2096
POST CATALYST FUEL TRIM SYS B1
(Post catalyst fuel trim system too lean bank
1)
The output voltage computed by ECM from the A/F sensor 1 s ...
Spark plug
Exploded view
Ignition coil
Spark plug
Rocker cover
Removal and installation
REMOVAL
Remove air duct assembly.
Remove ignition coil. Refer to EM-36, "Exploded View".
Remove spark plug using Tool.
Tool number : — (J-48891)
INSPECT ...
