Nissan Rogue (T33) 2021-Present Owner’s Manual & User Guide: Window washer fluid
Type A (if so equipped)
Type B (if so equipped)
For Type A systems on the Nissan Rogue, check the washer reservoir directly and refill with washer fluid when the level gets low.
For Type B systems, plug the center hole A of the cap/tube assembly with your finger and remove it from the reservoir. If no fluid appears inside the tube, add washer solution.
A quality washer solvent can improve cleaning, and during winter it is advisable to use a suitable windshield washer antifreeze. Always follow the manufacturer’s mixing instructions.
Refill the window washer reservoir regularly. Add fluid when the low-level warning appears (if equipped) and expect to refill more often if driving in dusty, muddy, or winter conditions where the Nissan Rogue uses more washer spray.
Recommended fluid: Genuine NISSAN Windshield Washer Concentrate Cleaner & Antifreeze or equivalent.
CAUTION
- Do not substitute engine antifreeze for washer solution — it can damage painted surfaces.
- Avoid pouring full-strength washer concentrates directly into the reservoir. Some methyl-alcohol mixtures may permanently stain the grille if spilled.
- Always pre-mix concentrates with water to the recommended ratio before filling the reservoir. Do not use the reservoir itself for mixing.
Window washer fluid
Type A (if so equipped)
Type B (if so equipped)
For Type A systems on the Nissan Rogue, check the fluid level directly in the washer reservoir and refill when the level is low.
For Type B ...
Air cleaner
To remove the filter on the Nissan Rogue, release the lock pins 1 and pull the unit upward 2.
The viscous paper filter element (if equipped) is not designed to be cleaned and reused. The dry p ...
Other materials:
System description
COMPONENT PARTS
POWER DOOR LOCK SYSTEM
POWER DOOR LOCK SYSTEM : Component Parts Location
No
Component
Function
1
BCM
Controls the door lock system.
Refer to BCS-7, "BODY CONTROL SYSTEM : Component Parts Location" for
detailed
install ...
Power supply and ground circuit
COMBINATION METER
COMBINATION METER : Diagnosis Procedure
Regarding Wiring Diagram information, refer to MWI-32, "Wiring Diagram".
1.CHECK FUSES
Check that the following fuses are not blown.
Is the fuse blown?
YES >> Replace the blown fuse after repairing the affected circu ...
Precaution
Precaution for Supplemental Restraint System (SRS) "AIR BAG" and "SEAT
BELT
PRE-TENSIONER"
The Supplemental Restraint System such as “AIR BAG” and “SEAT BELT PRE-TENSIONER”,
used along
with a front seat belt, helps to reduce the risk or severity of injury to the
...
