Nissan Rogue (T33) 2021-Present Owner’s Manual & User Guide: Turn signal switch

Nissan Rogue (T33) 2021-Present Owner’s Manual & User Guide / Instruments and controls / Headlight and turn signal switch / Turn signal switch

Nissan Rogue. Headlight and turn signal switch
Example

Turn signal

Move the lever up or down to indicate a turn. In the Nissan Rogue, the signal will cancel automatically once the turn is completed.

For models equipped with ProPILOT Assist 2.1: The lever returns to neutral after you move and release it. To cancel the signal, lightly move the lever to position 2 in the opposite direction and release it.

Lane change signal

To signal a lane change, move the lever up or down until the turn signal flashes without latching. Hold the lever until the lane change is complete.

You may also move the lever briefly until the indicator flashes, then release it—this causes the signal to blink three times automatically.

Select the appropriate signaling method based on road and traffic conditions to ensure safe operation of your Nissan Rogue.

Headlight switch

Basic information CAUTION Use headlights only with the engine running to prevent battery drain. Lighting Type A (if so equipped): Rotate the switch to the position to turn on the parking, tail ...

Horn

To sound the horn, press the center pad of the steering wheel. WARNING Do not disassemble the horn. Improper handling could affect proper operation of the supplemental front air bag system. Tamper ...

Other materials:

NISSAN vehicle immobilizer system
The NISSAN Vehicle Immobilizer system will not allow the engine to start without the use of the registered key. If the engine fails to start using a registered key (for example, when interference is caused by another registered key, an automated toll road device or automatic payment device o ...

Cluster lid A
Removal and Installation REMOVAL Remove instrument lower panel LH. Refer to IP-22, "Removal and Installation". Remove instrument finisher A. Refer to IP-15, "INSTRUMENT FINISHER A : Removal and Installation". Remove instrument finisher B. Refer to ...

Preparation
Special Service Tool The actual shape of the tools may differ from those illustrated here. Tool number (TechMate No.) Tool name Description — (J-39570) Chassis Ear Locating the noise — (J-50397) NISSAN Squeak and Rattle Kit ...