Basic information
WARNING
This is dangerous because the shoulder belt will not rest properly against your body. In a collision, you may be thrown forward and suffer neck or other serious injuries.
You could also slide under the lap belt and sustain serious internal injuries.
This can happen even when the vehicle is parked. Unbuckle the belt to free the child. If the belt cannot be unbuckled, cut it with a suitable tool such as a knife or scissors.
Fastening the seat belts
1. Adjust the seat.
2. Slowly pull the seat belt from the retractor and insert the tongue into buckle A until it clicks securely.
A slow pull allows freedom of movement while seated.
Then smoothly pull the belt out again.
3. Position the lap belt low and snug across the hips.
4. Pull the shoulder belt toward the retractor to remove slack.
Ensure the shoulder belt is routed over your shoulder and across your chest.
The three-point belts in the front passenger and rear seats operate in two modes:
The ELR mode allows the belt to extend and retract during normal driving. It locks during rapid deceleration or certain impacts.
The ALR mode (used for child restraints) locks the belt fully for installation. Once activated, the belt will not extend again until fully retracted and unbuckled.
The ALR mode should be used only for child restraint installation. Activating it during normal use may cause discomfort and may also affect front passenger air bag operation.
WARNING
When fastening seat belts, make sure the seatbacks are securely latched. Unlatched seatbacks may cause injury in sudden stops or collisions.
Unfastening the seat belts
To unfasten, press the button on buckle 1. The belt will automatically retract.
Checking seat belt operation
Seat belt retractors can lock in two situations:
To verify operation:
If the retractor on your Nissan Rogue does not lock during this check, have the system inspected. It is recommended that you visit a NISSAN dealer for this service or for additional information about proper seat belt operation.
Shoulder belt height adjustment (for front seats)
The shoulder belt anchor height should be adjusted to the position best suited for you to ensure proper protection while driving the Nissan Rogue.
To adjust, press the adjustment button, then slide the shoulder belt anchor to the desired height so the belt crosses the center of your shoulder.
The belt should stay clear of your face and neck without slipping off your shoulder.
Release the adjustment button to lock the shoulder belt anchor securely in position.
The available height adjustment range may vary slightly depending on the model and configuration of your Nissan Rogue.
WARNING
Seat belt hook
When the seat belts are not in use — especially when folding down the rear seats — secure the rear outer belts on the seat belt hooks provided.
WARNING
Before folding the rear seats back up, make sure the seat belts are not caught in the seatback latches to avoid damaging the belt webbing or affecting proper operation.
Seat belt warning light and chime
Seat belt extendersAnti-pinch system does not operate normally (driver side)
Diagnosis Procedure
1.PERFORM INITIALIZATION PROCEDURE
Initialization procedure is executed and operation is confirmed.
Refer to PWC-27, "ADDITIONAL SERVICE WHEN REMOVING BATTERY NEGATIVE TERMINAL :
Special
Repair Requirement".
Is the inspection result normal?
YES >> Insp ...
Fuel recommendation
Use unleaded regular gasoline with an octane
rating of at least 87 AKI (Anti-Knock Index) number
(Research octane number 91).
CAUTION
Only vehicles with the E-85 filler door
label can operate on E-85. Fuel system
or other damage can occur if E-85 is
used in vehicles t ...
Recommended fluids and lubricants
Fluids and Lubricants
*1: For additional information, see “Engine Oil Recommendation”.
*2: As an alternative to this recommended oil, SAE 5W-30 conventional petroleum
based oil may be used and meet all specifications
and requirements necessary to maintain the New Vehicle Limited Warra ...