Nissan Rogue (T33) 2021-Present Owner’s Manual & User Guide: Starting the engine
Basic information
1. Apply the parking brake.
2. Confirm that the vehicle is in the P (Park) position.
The Intelligent Key must be inside the vehicle when operating the ignition switch. This is essential for proper system recognition on your Nissan Rogue.
3. Push the ignition switch to the ON position, then depress the brake pedal and press the ignition switch again to start the engine.
To start the engine immediately, press and release the ignition switch while holding the brake pedal, regardless of the current switch position.
- If the engine is difficult to start in extremely cold conditions, gently press the accelerator pedal (about 1/3 of its travel) and hold it while cranking. Release the pedal once the engine starts.
- If the engine is flooded, fully depress the accelerator pedal and hold it. Press the ignition switch to crank for 5–6 seconds, then stop. Release the pedal and try starting normally. Repeat if needed.
CAUTION
Do not operate the starter for more than 15 seconds at a time. If the engine does not start, press the ignition switch to OFF and wait 10 seconds before retrying to avoid damaging the starter.
4. Warm-up
Allow the engine to idle for at least 30 seconds after starting. Do not race the engine during warm-up. Drive moderately at first, especially in cold weather. On a Nissan Rogue driven in winter conditions, keeping the engine running for 2–3 minutes before shutting it off helps prevent hard restarts.
When idling cold with no load, the engine speed is limited to approximately 3,000 rpm.
5. To stop the engine, shift to P (Park) and press the ignition switch to turn it OFF.
NOTE:
To avoid battery discharge and potential no-start situations, reduce long use of electronics when the engine is off (chargers, GPS, DVD players, etc.). Infrequent short-distance driving can also cause low battery charge.
In these situations, periodically charging the battery may be necessary for reliable operation of your Nissan Rogue.
- You may hear a sound under the passenger seat when starting or stopping the vehicle. This is normal and indicates proper operation of the ProPILOT Assist 2.1 battery (if equipped).
Remote engine start
Vehicles started remotely require the ignition switch to be placed in ON before shifting out of P (Park). To do this:
1. Carry the Intelligent Key with you.
2. Depress the brake pedal.
3. Press the ignition switch once to enter the ON mode.
Push-button ignition switch
Basic information
WARNING
Do not operate the push-button ignition switch while driving the vehicle unless it is an emergency. The engine in the Nissan Rogue will shut off if the switch is pushed three ...
Driving the vehicle
Continuously Variable Transmission (CVT)
Basic information
The CVT in the Nissan Rogue is electronically controlled to deliver smooth, efficient performance. Following the recommended driving proced ...
Other materials:
Front seat
Exploded View
DRIVER POWER SEAT
Headrest
Seatback support
Seatback board
Seatback heater (if equipped)
Seatback trim
Seatback pad
Seat cushion outer finisher (RH)
Seat cushion rear finisher
(RH)
Seat cushion inner finisher (RH)
Seat sli ...
Radio Antenna
The antenna on the Nissan Rogue is located on the rear part of the vehicle roof and is designed to provide stable radio reception during everyday driving.
CAUTION
A build-up of ice on the antenna can affect radio performance.
Remove the ice to restore proper radio reception on your Nissan Rogue.
...
Basic information
Instrument panel
Luggage area (if so equipped)
The Nissan Rogue is equipped with power outlets located in the lower part of the instrument panel and, on some models, in the luggage area. These outlets allow you to power small electronic accessories while on the road.
CAUTION
The outlet and ...
