Nissan Rogue (T33) 2021-Present Owner’s Manual & User Guide: Rain-sensing auto wiper system
The rain-sensing auto wiper system automatically activates and adjusts wiper speed based on rainfall and vehicle speed. The rain sensor is located near the top of the windshield in the Nissan Rogue.
To enable the system, push the lever down to AUTO position 1. The wiper will sweep once with the ignition ON.
The sensitivity level can be adjusted by turning the knob toward 2 (Low) or (High):
- High — higher sensitivity
- Low — lower sensitivity
To turn the rain-sensing system off, push the lever up to OFF, or move it down to another position.
NOTE:
The rain sensor may be disabled.
CAUTION
Do not touch the rain sensor when the switch is in AUTO and the ignition is ON, as the wipers may activate unexpectedly.
- The rain-sensing system is intended for rainfall use. If left in AUTO, wipers may activate when dirt, fingerprints, insects, exhaust gas, or moisture affect the sensor.
- If the windshield has a water-repellent coating, the wiper speed may increase even with light rain.
- Turn off the rain-sensing system before using a car wash.
- The system may not activate if rainwater does not reach the sensor area.
- Using genuine wiper blades is recommended to maintain proper operation of the Nissan Rogue rain-sensing system.
Basic information
WARNING
In freezing temperatures, the washer solution may freeze on the windshield and limit visibility, increasing the risk of an accident. Warm the windshield with the defroster before using the was ...
Rear window wiper and washer operation
WARNING
In freezing temperatures, the washer solution may freeze on the rear window and reduce visibility. Warm the glass with the defroster before using the washer.
CAUTION
Do not operate the wash ...
Other materials:
Preparation
Special Service Tools
The actual shape of the tools may differ from those illustrated here.
Tool number
(TechMate No.)
Tool name
Description
—
(J-44372)
Pull gauge
Measuring steering wheel turning force, rack
sliding force and ball joint swinging ...
Removal and installation
IPDM E/R (INTELLIGENT POWER DISTRIBUTION MODULE ENGINE
ROOM)
Exploded View
IPDM E/R cover
IPDM E/R
IPDM E/R case
IPDM E/R harness cover A
IPDM E/R harness cover B
Front
Removal and Installation
CAUTION: IPDM E/R integrated relays are not serviceable
parts, do not ...
Auto operation does not operate
MOONROOF
MOONROOF : Diagnosis Procedure
1. PERFORM INITIALIZATION PROCEDURE
Perform initialization procedure.
Refer to RF-24, "ADDITIONAL SERVICE WHEN REPLACING CONTROL UNIT : Special Repair
Requirement".
Is the inspection result normal?
YES >> Moonroof system is normal.
...
