Nissan Rogue manuals

Nissan Rogue Service Manual: Preparation

Special Service Tool

The actual shape of the tools may differ from those illustrated here.

Tool number (TechMate No.) Tool name Description
— (J-46534) Trim Tool Set

Removing trim component
Precaution
Precaution for Supplemental Restraint System (SRS) "AIR BAG" and "SEAT BELT PRE-TENSIONER" The Supplemental Restraint System such as “AIR BAG” and “SEAT BELT PRE-TENSIO ...

Basic inspection
COMPONENT INSPECTION Inspection AFTER A COLLISION WARNING: Inspect all seat belt assemblies including retractors and attaching hardware after any collision. NISSAN/INFINITI recommends that al ...

Other materials:

VDC off switch
Removal and Installation REMOVAL  Remove the instrument lower panel LH. Refer to IP-14, "INSTRUMENT PANEL ASSEMBLY : Removal and Installation".  Release pawls using suitable tool and remove the VDC OFF switch (2) from the upper switch carrier (1). : Pawl INST ...

Calibration of decel G sensor
Description CAUTION: Always perform the decel G sensor calibration before driving when the following operation is performed. NOTE: Yaw rate/side/decel G sensor calibration is performed when performing the decel G sensor calibration. Work Procedure Decel G sensor calibration CAUTION: ...

Refrigerant pressure sensor
Component Function Check 1.CHECK REFRIGERANT PRESSURE SENSOR FUNCTION  Start engine and warm it up to normal operating temperature.  Turn A/C switch and blower fan switch ON.  Check the voltage between ECM harness connector terminals under the following conditions. ...

© 2014-2026 Copyright t32.nirogue.com