Nissan Rogue Service Manual: Parking brake shoe
Inspection and Adjustment
- Adjust parking brake pedal stroke. Refer to PB-4, "Inspection and Adjustment".
- Perform parking brake break-in (drag on) operation by driving vehicle under the following conditions:
- Drive forward
- Vehicle speed: Approx. 40 km/h (25 MPH) set (constant and forward)
- Parking brake operating force: Approx. 160 +30.0 N (16.3 +3.1 kg-f, 36.0 +6.7 lb-f)
- Time: Approx. 10 +5.0 seconds.
CAUTION: To prevent lining from getting too hot, allow a cool off period of approximately 5 minutes after every break-in operation.
- After the break-in procedure, check parking pedal stroke of parking brake.
CAUTION: If it is out of the specification, adjust again. Refer to PB-4, "Inspection and Adjustment".
ADJUSTMENT AFTER INSTALLATION
- Adjust the parking brake pedal stroke. Refer to PB-4, "Inspection and Adjustment".
- Rotate the disc brake rotor with the parking brake pedal released
and check that there is no drag.
CAUTION: If any drag is found, verify the parking brake components are installed and adjusted correctly.
Parking brake system
Inspection and Adjustment
INSPECTION
Pedal Stroke
Operate the parking brake pedal with a force of 196 N (20.0 kg-f,
44.1 lb-f). Check that the pedal stroke is
within the specified num ...
Other materials:
Reporting safety defects
For USA
If you believe that your vehicle has a defect
which could cause a crash or could
cause injury or death, you should immediately
inform the National Highway Traffic
Safety Administration (NHTSA) in addition
to notifying NISSAN.
If NHTSA receives similar complaints, it
may open an inv ...
Periodic maintenance
FUEL SYSTEM
Inspection
Inspect fuel lines, fuel filler cap, and fuel tank for improper attachment,
leaks, cracks, damage, loose connections, chafing or deterioration.
(A) : Engine
(B) : Fuel line
(C) : Fuel tank
If necessary, repair or replace damaged parts.
Quick Connector
CAUTION:
...
P0967 pressure control solenoid B
DTC Description
DTC DETECTION LOGIC
DTC
CONSULT screen terms
(Trouble diagnosis content)
DTC detection condition
P0967
PC SOLENOID B
(Pressure Control Solenoid B Control Circuit
High)
When all of the following conditions are satisfied and this state is
main ...
