Nissan Rogue (T33) 2021-Present Owner’s Manual & User Guide: LDW system operation
- LDW indicator in the vehicle information display
- Vehicle information display
- Steering-wheel-mounted controls (left side)
When lane departure is detected, the LDW indicator flashes and the steering wheel vibrates. The alert stops once the vehicle returns to the lane. Vibration strength can be adjusted in the settings menu.
How to enable/disable the LDW system
- Press the
button until “Settings” appears, then press the scroll dial. - Select “Driver Assistance,” then select “Lane Assist.”
- Select “Warning” and confirm to enable or disable LDW.
NOTE:
If disabled, the LDW system remains off the next time the Nissan Rogue is started.
Basic information
WARNING
Incorrect use of the LDW system may lead to serious injury. This feature only warns the driver of unintended lane departure; it does not steer the Nissan Rogue or prevent loss of control. The ...
LDW system limitations
WARNING
Not all conditions allow the LDW system to function properly. Misuse can lead to an unsafe driving situation.
The system will not work below 37 MPH (60 km/h) or when lane markings are not v ...
Other materials:
Air cleaner
Air cleaner
The air cleaner filter should not be cleaned and
reused. Replace it according to the maintenance
log shown in the “NISSAN Service and Maintenance
Guide.”
To remove the air cleaner filter:
Unlatch the retaining clips A .
Pull up at points B and remove.
...
P0443 EVAP canister purge volume control solenoid valve
DTC Description
DTC DETECTION LOGIC
DTC No.
CONSULT screen terms
(Trouble diagnosis content)
DTC detecting condition
P0443
PURG VOLUME CONT/V
(Evaporative emission system purge control
valve circuit)
A
The canister purge flow is detected during the vehicle i ...
Power supply and ground circuit
COMBINATION METER
COMBINATION METER : Diagnosis Procedure
Regarding Wiring Diagram information, refer to MWI-32, "Wiring Diagram".
1.CHECK FUSES
Check that the following fuses are not blown.
Is the fuse blown?
YES >> Replace the blown fuse after repairing the affected circu ...
