Nissan Rogue (T33) 2021-Present Owner’s Manual & User Guide: Jump starting
To start your engine using a booster battery, carefully follow the instructions and precautions below.
WARNING
- Incorrect jump starting can cause a battery explosion, leading to severe injury or death.
- Explosive hydrogen gas is always present around the battery. Keep all sparks, flames, and cigarettes away.
- Avoid contact with battery fluid. It is corrosive sulfuric acid that can cause severe burns. If contact occurs, immediately flush with water.
- Keep the battery out of the reach of children.
- Use only a 12-volt booster battery. An incorrect voltage can severely damage your vehicle.
- Wear eye protection and remove all metal jewelry before working near a battery. Do not lean over the battery during jump starting.
- Do not attempt to jump start a frozen battery — it can explode.
- Your vehicle has an automatic cooling fan that may turn on at any time. Keep hands and tools away.
WARNING
Always follow the instructions below. Failure to do so may damage the charging system or cause personal injury.
Jump starting procedure
1. If the booster battery is in another vehicle, position the two vehicles (A and B) so the batteries are close together. Do not allow the vehicles to touch.
2. Apply the parking brake.
3. Push the park button to select the P (Park) position.
4. Turn off all unnecessary electrical systems (lights, heater, A/C, etc.).
5. Connect the jumper cables in the exact order shown (1 → 2 → 3 → 4).
CAUTION
- Always connect positive (+) to positive (+), and negative (−) to a solid engine ground — never to the battery’s negative terminal in your vehicle.
- Ensure the jumper cables do not touch any moving engine parts or other metal surfaces.
6. Start the booster vehicle (B) and let its engine run for a few minutes.
7. Hold the booster vehicle engine speed at around 2,000 rpm, then attempt to start vehicle A.
CAUTION
- Do not crank the engine for more than 10 seconds. If it does not start, turn the ignition OFF and wait at least 10 seconds before trying again.
- If the engine still does not start: - Turn off the booster vehicle engine, - Turn ignition OFF, - Open and close the driver’s door once (with the Intelligent Key inside), - Keep the door closed and wait at least 3 minutes without performing any operations. Then repeat the procedure from step 6.
8. Once your engine starts, carefully disconnect the jumper cables in reverse order (4 → 3 → 2 → 1).
Jacking up the vehicle and removing the damaged tire
WARNING
Never go under the vehicle when it is supported only by a jack. Use safety stands if you need to work underneath.
Use only the vehicle’s supplied jack when lifting your Nissan. It is desi ...
Push starting
Do NOT attempt to push start the vehicle.
CAUTION
CVT models cannot be push-started or tow-started. Attempting to do so may severely damage the transmission.
Vehicles equipped with a three-w ...
Other materials:
Shortcut Menu
When the button is pressed, the "Shortcut Menu" appears on the Nissan Rogue vehicle information display. Turn the scroll dial to highlight an item, then press to select.
The following shortcut options are available:
Change Meter View (if equipped)
Allows the driver to select ...
Basic inspection
DIAGNOSIS AND REPAIR WORK FLOW
Work flow
OVERALL SEQUENCE
DETAILED FLOW
1.OBTAIN INFORMATION ABOUT SYMPTOM
Interview the customer to obtain as much information as possible about the
conditions and environment under
which the malfunction occurred.
>> GO TO 2.
2.CHECK SYMPTOM
...
CAN system (type 7)
MAIN LINE BETWEEN IPDM-E AND DLC CIRCUIT
Diagnosis Procedure
1.CHECK CONNECTOR
Turn the ignition switch OFF.
Disconnect the battery cable from the negative terminal.
Check the following terminals and connectors for damage, bend and
loose connection (connector side
an ...
