Nissan Rogue (T33) 2021-Present Owner’s Manual & User Guide: I-BSI system operation
- Side indicator light
- I-BSI ON indicator
- I-BSI warning indicator
- Vehicle information display
- ProPILOT Assist switch
The I-BSI system functions above approximately 37 MPH (60 km/h).
If a vehicle enters the detection zone, the side indicator light turns on.
If the turn signal is activated while a vehicle is detected, the system chimes twice and both the side indicator and I-BSI indicator flash.
If I-BSI is ON and your vehicle drifts toward a lane marker while another vehicle is detected, the system chimes three times and flashes both indicators.
The system may also apply brief steering assistance to help guide the vehicle back toward the center of the lane.
Use the ProPILOT Assist switch to turn the system ON or OFF. The indicator will illuminate when active.
NOTE:
- I-BSI warnings and steering assistance only occur if a vehicle is already detected when your vehicle approaches the lane marker.
- The I-BSI system typically activates earlier than Intelligent Lane Intervention (I-LI) when approaching a lane boundary.
Basic information
WARNING
Failure to follow the instructions and limitations of the I-BSI system could result in serious injury or death.
The I-BSI system does not replace safe driving practices. Always check mi ...
How to enable/disable the I-BSI system
Press the button until “Settings” appears, then press the scroll dial.
Select “Driver Assistance” using the scroll dial.
Select “Blind Spot Assist” and press the scroll dial.
Sel ...
Other materials:
Front wiper motor
Removal and Installation
REMOVAL
Remove the front drive assembly. Refer to WW-66, "Removal and
Installation".
Remove the bolts (A) from the front wiper drive assembly (1)
and the front wiper motor (2).
Separate the wiper motor (1) from the front wiper drive ...
Cleaning interior
Basic information
From time to time, remove loose dust from the interior trim, plastic elements and seats of the Nissan Rogue using a vacuum cleaner or a soft-bristle brush.
Vinyl and leather areas should be wiped with a clean, soft cloth dampened in mild soapy water and then dried with another cl ...
Symptom diagnosis
SQUEAK AND RATTLE TROUBLE DIAGNOSES
Work Flow
CUSTOMER INTERVIEW
Interview the customer if possible, to determine the conditions that exist
when the noise occurs. Use the Diagnostic
Worksheet during the interview to document the facts and conditions when the
noise occurs and any
custome ...
