Nissan Rogue (T33) 2021-Present Owner’s Manual & User Guide: Heated seats
WARNING
Do not use, or allow others to use, the seat heater if you or the occupant cannot monitor seat temperature or have reduced ability to feel pain in areas contacting the seat. This may result in serious injury.
CAUTION
- Running the heater while the engine is off may drain the battery.
- Avoid using the seat heater for extended periods or when the seat is empty.
- Do not place thick or insulating materials such as blankets or cushions on the seat, as heat may build up excessively.
- Do not place heavy objects or puncture the seat with sharp items to prevent damage to the heating element.
- Wipe away any spilled liquids immediately with a dry cloth.
- Do not use gasoline, thinner, or similar chemicals to clean the seat.
- If the heated seat malfunctions, turn it off and have the system inspected by a NISSAN dealer.
Front
Rear (if so equipped)
The front and rear seats (if equipped) are warmed by built-in heaters. The switches are located on the instrument panel and on the rear of the center console, allowing independent operation for each seat in the Nissan Rogue.
Operation with switch
1. Start the engine.
2. Push the heated seat switch and select your preferred heat level.
- Press once for high heat.
- Press twice for medium heat.
- Press three times for low heat.
- The indicator light 1 on the switch illuminates to show the selected level.
3. To turn the heater off, press the switch until the indicator light goes out.
The system uses a control module that automatically regulates heat output according to the chosen setting, maintaining passenger comfort.
The indicator light remains illuminated as long as the heater is on.
After the interior warms or before leaving the vehicle, be sure to turn off the seat heaters to conserve battery power.
Heated steering wheel
Example
Push the heated steering wheel switch to warm the steering wheel after the engine starts. The indicator light A will illuminate once the system is active.
If the steering wheel surface tem ...
Steering Assist switch (models with ProPILOT Assist)
The Steering Assist switch allows you to temporarily turn the Steering Assist system on or off whenever needed.
You can also enable or disable Steering Assist via the “Driver Assistance” menu ...
Other materials:
BSW driving situations
Another vehicle approaching from behind
The Blind Spot indicator light illuminates if a
vehicle enters the detection zone from behind in
an adjacent lane.
However, if the overtaking vehicle is traveling
much faster than your vehicle, the indicator light
may not illuminate before the dete ...
Car phone or CB radio
When installing a car phone or CB radio in your Nissan Rogue, follow these precautions to avoid interference with electronic modules or wiring systems.
WARNING
Do not use a handheld cellular phone while driving. It is unsafe and may be prohibited in some regions.
If a call must be made while the ...
P1574 ASCD vehicle speed sensor
Description
The ECM receives two vehicle speed sensor signals via CAN communication line.
One is sent from combination
meter, and the other is from TCM (Transmission control module). The ECM uses
these signals for ASCD
control. Refer to EC-47, "AUTOMATIC SPEED CONTROL DEVICE (ASCD) : Sys ...
