Nissan Rogue (T33) 2021-Present Owner’s Manual & User Guide: Garage mode system
The liftgate can be set to open to a specific height by performing the following:
1. Open the liftgate.
2. Pull the liftgate down to the desired position and hold the liftgate (the liftgate will have some resistance when being manually adjusted).
3. While holding the liftgate in position, press and hold the power liftgate close and lock switch located on the liftgate for approximately 3 seconds or until 2 beeps are heard.
The liftgate will open to the selected position setting. To change the position of the liftgate, repeat steps 1-3 for setting the position of the liftgate. This function is especially useful when parking the Nissan Rogue in garages with low ceilings.
CAUTION
Do not set the height of the liftgate below approximately 1/3 of the way to the floor using garage mode. Even if you set the height below approximately 1/3 of the way to the floor, the height will automatically be set to approximately 1/3 of the way to the floor.
Auto closure
When the liftgate reaches the secondary position, the closure motor engages and pulls the liftgate to its primary latch position.
Do not apply excessive force when the auto closure is operating. Excessive force applied may cause the mechanism to malfunction.
CAUTION
- The liftgate will automatically close from the secondary position.
- Do not let children operate the liftgate.
To avoid pinching, keep hands and fingers away from liftgate opening.
Liftgate release lever
If the liftgate cannot be opened with the power door lock switch due to a discharged battery, follow these steps.
1. Fold the rear seats down.
2. Insert a suitable tool in the access opening. Move the release lever to the left. The liftgate will be unlatched.
3. Push the liftgate up to open.
Contact a NISSAN dealer as soon as possible for repair.
Motion-activated liftgate
Basic information
The Nissan Rogue liftgate can be opened using a quick forward kicking motion beneath the center area of the rear bumper.
The kick motion sensor a is located behind the bumper ...
Fuel-filler door
Basic information
CAUTION
Avoid applying direct water pressure,
such as high-pressured
sprayer, on or around the fuel-filler
door.
Be sure to close the fuel-filler door
before using an automat ...
Other materials:
Tire pressure
Tire Pressure Monitoring System
(TPMS)
WARNINGRadio waves could adversely affect electric
medical equipment. Those who use a
pacemaker should contact the electric
medical equipment manufacturer for the
possible influences before use
This vehicle is equipped with TPMS. It m ...
P0456 EVAP control system
DTC Description
DTC DETECTION LOGIC
This diagnosis detects leaks in the EVAP line between fuel tank and EVAP
canister purge volume control solenoid
valve, using the negative pressure caused by decrease of fuel temperature in the
fuel tank after turning
ignition switch OFF.
If ECM judges t ...
Preparation
Special service tool
The actual shapes of techmate tools may differ from those of special service
tools illustrated here.
Tool number
(techmate no.)
Tool name
Description
St33061000
(j-8107-2)
drift
a: 38 mm (1.50 In) dia.
B: 28.5 Mm (1.122 In) dia.
Re ...
