Basic information
CAUTION
Opening the fuel-filler door

To open the fuel-filler door, push the middle left side of the door. This design makes refueling the Nissan Rogue quick and convenient.
How to refuel

The fuel tank is not equipped with a fuel-filler cap. After opening the fuel-filler door, insert the fuel pump nozzle directly into the fuel-filler opening. When the fuel pump nozzle is pulled out, the fuel-filler opening will be sealed, helping maintain proper pressure in the Nissan Rogue fuel system.
To refuel: Be sure to insert the fuel pump nozzle slowly into the fuel-filler opening as far as it will go before fueling.
Never move the nozzle during refueling.
Pull out the nozzle approximately 5 seconds after the fuel pump nozzle shuts off automatically (initial shut-off). This helps maintain proper fuel pressure in the Nissan Rogue fuel system.
Close the fuel-filler door after refueling.
If you need to refuel from a portable fuel container, use the funnel supplied with your vehicle.
CAUTION
WARNING
Continued refueling may cause fuel overflow, resulting in fuel spray and possibly a fire.
Static electricity can cause an explosion of flammable liquid, vapor or gas in any vehicle or trailer. To reduce the risk of serious injury or death when filling portable fuel containers:
When refueling from a portable fuel container

If you need to refuel from a portable fuel container, use the funnel A stored in the tool bag (located under the luggage board).
Be sure to insert the funnel into the fuel-filler opening slowly and fully. Insert the nozzle of the portable fuel container into the opening along the funnel and fill the fuel tank of your Nissan Rogue carefully.
After refueling, remove the funnel from the fuel-filler opening. Wipe the funnel clean and return it to the tool bag.
CAUTION
Garage mode system
Tilt/telescopic steeringNISSAN vehicle immobilizer system
The NISSAN Vehicle Immobilizer System will not
allow the engine to start without the use of a
registered key.
Never leave these keys in the vehicle.
FCC Notice:
For USA:
This device complies with part 15 of the
FCC Rules. Operation is subject to the following
two conditions: (1) This device ...
Motion-activated liftgate
Basic information
The Nissan Rogue liftgate can be opened using a quick forward kicking motion beneath the center area of the rear bumper.
The kick motion sensor a is located behind the bumper. When your foot moves under and away from the detection area b while carrying the Intelligent Key, ...
U1001 CAN comm circuit
Description
CAN (Controller Area Network) is a serial communication line for real time
application. It is an on-vehicle multiplex
communication line with high data communication speed and excellent error
detection ability. Many electronic
control units are equipped onto a vehicle, and each co ...