Basic information
The following descriptions are provided to give you a better understanding of the scheduled maintenance items that should be regularly checked or replaced on the Nissan Rogue.
The maintenance schedule indicates at which mileage/time intervals each item requires service.
In addition to scheduled maintenance, your vehicle requires that some items be checked during normal day-to-day operation.
Items marked with "*" are recommended by NISSAN for reliable vehicle operation.
You are not required to perform maintenance on these items in order to maintain the warranties which come with your vehicle. Other maintenance items and intervals are required.
When applicable, additional information can be found in the "8. Do-it-yourself" section of this manual.
NOTE:
NISSAN does not advocate the use of non-OEM approved aftermarket flushing systems and strongly advises against performing these services on a NISSAN product. Many of the aftermarket flushing systems use non-OEM approved chemicals or solvents, the use of which has not been validated by NISSAN.
Emission control system maintenance
Engine drive belts*: Check engine drive belt for wear, fraying or cracking and for proper tension.
Replace any damaged drive belt.
Air cleaner filter: Replace at specified intervals. When driving for prolonged periods in dusty conditions, check/replace the filter more frequently.
Engine coolant*: Replace coolant at the specified interval.
When adding or replacing coolant, be sure to use only Genuine NISSAN Long Life Antifreeze/Coolant (blue) or equivalent with the proper mixture.
NOTE:
Mixing any other type of coolant or the use of non-distilled water may reduce the recommended service interval of the coolant.
Intercooler coolant: Intercooler coolant is maintenance-free.
Engine oil and oil filter: Replace engine oil and oil filter at the specified intervals. For recommended oil grade and viscosity refer to "Capacities and recommended fluids/lubricants".
Engine valve clearance*: Inspect only if valve noise increases.
Adjust valve clearance if necessary.
Fuel tank vapor vent system*: Check vapor lines for leaks or looseness.
Tighten connections or replace parts as necessary.
Fuel filter: Periodic maintenance is not required (in-tank type filter).
Fuel lines/connections*: Check the fuel hoses, piping and connections for leaks, looseness, or deterioration.
Tighten connections or replace parts as necessary.
Spark plugs: Replace at specified intervals. Install new plugs of the type as originally equipped.
Chassis and body maintenance
Brake lines and cables: Visually inspect for proper installation.
Check for chafing, cracks, deterioration, and signs of leaking. Replace any deteriorated or damaged parts immediately.
Brake pads and rotors: Check for wear, deterioration and fluid leaks. Replace as necessary.
Exhaust system: Visually inspect the Nissan Rogue exhaust pipes, muffler and hangers for leaks, cracks, deterioration, and damage. Tighten connections or replace parts as needed.
In-cabin microfilter: Replace at specified intervals. When driving for prolonged periods in dusty conditions, replace the filter more frequently.
Propeller shaft(s): Check for damage, looseness, and grease leakage. (AWD)
Steering gear and linkage, axle and suspension parts, drive shaft boots: Check for damage, looseness, and leakage of oil or grease. Under severe driving conditions, inspect more frequently.
Tire rotation: Rotate tires at the specified interval.
Transmission fluid/oil, differential gear oil, coupling oil and transfer fluid:
Visually inspect for signs of leakage at specified intervals.
If using a car-top carrier, or towing a trailer, or using a camper, or driving on rough or muddy roads:
General maintenance
Maintenance schedulesPrecaution
Precautions
Precaution for Supplemental Restraint System (SRS) "AIR BAG" and "SEAT
BELT
PRE-TENSIONER"
The Supplemental Restraint System such as “AIR BAG” and “SEAT BELT PRE-TENSIONER”,
used along
with a front seat belt, helps to reduce the risk or severity of inj ...
CVT fluid cooler system
Cleaning
Whenever an automatic transaxle is repaired, overhauled, or replaced, the CVT
fluid cooler mounted in the
radiator must be inspected and cleaned.
Metal debris and friction material, if present, can be trapped or be deposited
in the CVT fluid cooler. This
debris can contaminate the ...
Front passenger air bag module
Exploded View
Front passenger air bag module
Steering member
Removal and Installation
WARNING:
Before servicing the SRS, turn ignition switch OFF, disconnect
both battery terminals then wait at
least three minutes.
Always work from the side of air bag module. Do ...