WARNING
Failure to follow the warnings and instructions for proper use of the I-FCW system on the Nissan Rogue could result in serious injury or death.
The I-FCW system helps notify the driver when it detects sudden braking from a second vehicle traveling ahead of the one directly in front of the Nissan Rogue in the same lane.

The I-FCW system uses a radar sensor A mounted at the front of the Nissan Rogue to measure the distance to the second vehicle ahead.

I-FCW system operation

The I-FCW system activates at speeds above approximately 3 MPH (5 km/h).
If the Nissan Rogue detects a potential forward collision risk, the I-FCW system warns the driver by flashing the vehicle-ahead indicator and sounding an audible alert.
Turning the I-FCW system ON/OFF

Perform the
following steps to turn the I-FCW system on or off on your Nissan Rogue:
1. Press the button until “Settings” appears on the vehicle information display, then push the scroll dial. Use the scroll dial to choose “Driver Assistance” and confirm.
2. Select “Emergency Assist” and press the scroll dial.
3. Choose “Emergency Braking” and use the scroll dial to turn the I-FCW system on or off.
When the I-FCW system is turned off, the AEB system OFF warning light (orange) illuminates.
NOTE:
I-FCW system limitationsLumbar support switch
Exploded View
Seat cushion outer finisher
Lumbar support switch
Clip
Pawl
Removal and Installation
REMOVAL
Using a suitable tool release clips and remove seat cushion
outer finisher (1).
: Clip
Disconnect harness connector from lumbar support switch.
...
Removal and installation
AUDIO UNIT
Exploded View
Audio unit bracket (LH)
Audio unit
Audio unit bracket (RH)
Removal and Installation
REMOVAL
Disconnect the negative battery terminal. Refer to PG-75, "Removal
and Installation (Battery)".
Remove A/C switch (AUTOMATIC AI ...
Symptom diagnosis
SQUEAK AND RATTLE TROUBLE DIAGNOSES
Work Flow
CUSTOMER INTERVIEW
Interview the customer if possible, to determine the conditions that exist
when the noise occurs. Use the Diagnostic
Worksheet during the interview to document the facts and conditions when the
noise occurs and any
custome ...