Nissan Rogue (T33) 2021-Present Owner’s Manual & User Guide: Basic information
- CAMERA button
WARNING
- Failure to follow the warnings and instructions for proper use of the Intelligent Around View Monitor system on your Nissan Rogue could result in serious injury or death.
- The Intelligent Around View Monitor is a convenience system and must not replace safe driving practices. It contains blind-spot zones where objects may not appear, especially near the four corners of the vehicle. Always visually check your surroundings before moving your Nissan Rogue.
- The driver is responsible for safe operation at all times.
CAUTION
Do not scratch the lens when cleaning dirt, ice or snow from the camera.
The Intelligent Around View Monitor assists the driver during parking maneuvers such as slot or parallel parking. The system displays multiple camera angles in a split-screen layout, giving a clearer understanding of the Nissan Rogue surroundings.
Available views:
- Front view — displays the area directly ahead of the vehicle
- Rear view — shows the rear surroundings
- Bird’s-eye view — a simulated top-down 360° view around the Nissan Rogue
- Front-side view — shows the area around the driver-side or passenger-side wheels
- Rear-side view (Rock Creek models)
- Front-wide and Rear-wide views
- 3D view (if equipped) — a 360-degree model around the vehicle
- Invisible Hood View — displays the front area with a transparent simulated hood
Intelligent Around View Monitor system operation
The system uses cameras positioned on the grille, under the outside mirrors, and above the rear license plate. When the ignition is ON, pressing the CAMERA button or shifting into R activates the In ...
Other materials:
Steering wheel
Inspection
STEERING WHEEL AXIAL END PLAY
Check installation conditions of steering gear, front suspension
assembly, axle and steering column.
Check if movement exists when steering wheel is moved up and down,
to the left and right and to the axial
direction.
Steering wh ...
Basic inspection
CONFIGURATION (CAN GATEWAY)
Work Procedure
1.WRITING MODE SELECTION
CONSULT Configuration
Select “Re/programming, Configuration” of CAN gateway.
When writing saved data>>GO TO 2.
When writing manually>>GO TO 3.
2.PERFORM “AFTER REPLACE ECU” OF “READ / WRITE CONFIGURA ...
ECU diagnosis information
TCM
Reference Value
CONSULT DATA MONITOR STANDARD VALUE
In CONSULT, electric shift timing or lock-up timing, i.e.
operation timing of each solenoid valve, is displayed.
Therefore, if there is an obvious difference between the shift timing
estimated from a shift shock (or engine
...
