WARNING
The Nissan Rogue Intelligent Key system allows remote locking and unlocking using the key fob or request switch (if equipped), without removing the key from a pocket or bag.
Environmental conditions may affect Intelligent Key performance, so it is important to understand the factors that can influence operation.
CAUTION
The Intelligent Key continuously exchanges low-power radio signals with the vehicle. These signals may be disrupted under the following conditions:
In such situations, adjust the surrounding conditions before using the Nissan Rogue Intelligent Key system, or operate the vehicle using the mechanical key instead.
The battery life of the Intelligent Key varies depending on usage and environment, but on average, it lasts for approximately 2 years.
If the battery becomes weak or fully discharged, replace it with a new battery to ensure proper Nissan Rogue key functionality.
When the Intelligent Key battery is low, a warning indicator will appear on the Nissan Rogue information display.
Because the Intelligent Key constantly receives radio signals, storing it near devices that emit strong electromagnetic noise—such as televisions, wireless routers, or personal computers—can shorten its battery life.
Up to four Intelligent Keys can be registered for a single Nissan Rogue. For purchasing or registering additional keys, it is recommended to contact a NISSAN dealer.
CAUTION
If an Intelligent Key is lost or stolen, NISSAN recommends erasing its ID code from the Nissan Rogue system to prevent unauthorized vehicle access.
Erasing the Intelligent Key ID will disable that key permanently, helping protect the vehicle from misuse.
For details about key ID erasure, contact a NISSAN dealer for assistance.
For vehicles equipped with request switches, the Intelligent Key functionality can also be disabled. For more information about disabling the Nissan Rogue Intelligent Key system, consult your NISSAN dealer.
Intelligent Key operating range (models with request switch)Fuel pressure
Work Procedure
FUEL PRESSURE RELEASE
1.FUEL PRESSURE RELEASE
With CONSULT
Turn ignition switch ON.
Perform “FUEL PRESSURE RELEASE” in “WORK SUPPORT” mode of “ENGINE”
using CONSULT.
Start engine.
After engine stalls, crank it two or three times to ...
System description
COMPONENT PARTS
Component Parts Location
Right rear wheel area
Instrument panel
Engine compartment
Left side of instrument panel (view
with trim panel removed)
No.
Part
Function
1
Optical sensor
Refer to EXL-140, "Optical Senso ...
DTC/circuit diagnosis
U0428 STEERING ANGLE SENSOR
DTC Logic
DTC DETECTION LOGIC
CONSULT Display
DTC Detection Condition
Possible Cause
ST ANG SEN CALIB
[U0428]
Predictive course line center position adjustment
of steering angle sensor is incomplete.
Adjust predictive cours ...