Nissan Rogue (T33) 2021-Present Owner’s Manual & User Guide: Auto-reverse function (driver's side)
WARNING
There is a small range just before the fully closed position where objects may not be detected. Make sure all passengers keep their hands and other body parts inside the Nissan Rogue before closing the window.
The auto-reverse function automatically lowers the window if an object is detected while the window is closing using the automatic operation. When the control unit senses an obstruction, the window immediately reverses direction.
Depending on conditions, the auto-reverse function may also activate if an impact or load similar to an obstruction is applied to the window.
Window timer:
The window timer allows the switches to operate for a short time even after the ignition switch is turned to the OFF position. The timer is canceled when the driver’s or front passenger’s door is opened or when the preset time expires.
When power window switch does not operate
If the automatic function of the power windows does not operate correctly, initialize the system using the following procedure.
1. Close the door.
2. Place the ignition switch in the ON position.
3. Pull the power window switch and hold it until the window is fully closed.*1
4. Release the power window switch.
5. Pull the power window switch again and hold it for approximately 5 seconds or more.*2
6. Push the power window switch down and hold it until the window is fully opened.
7. Release the power window switch.
8. Push the power window switch down and hold it for approximately 5 seconds or more.*2
9. Pull the power window switch and hold it until the window is fully closed.*1
10. Use the automatic open/close function to confirm that initialization is complete.
*1: If the window stops before it reaches the fully closed position, release the switch, then pull and hold it again to fully close the window.
*2: After pulling or pushing the power window switch and holding it for approximately 5 seconds or more, the window will move again.
If the window cannot be closed automatically because the auto-reverse function activates due to a malfunction, use the following steps to cancel auto-reverse.
1. Pull the power window switch up until the auto-reverse function activates and the window reverses automatically.
2. Repeat this operation twice.
3. Pull the power window switch and hold it to fully close the window and confirm that cancellation is complete.
WARNING
When the auto-reverse function is canceled, the window will not reverse automatically even if an obstacle is detected. Always confirm that passengers keep their hands and other body parts inside the vehicle before closing the windows.
If the power windows still do not operate properly after performing these steps, have your Nissan Rogue inspected by a NISSAN dealer.
Power windows
Basic information
WARNING
Make sure all passengers keep their hands and other body parts inside the vehicle while it is moving and before you close the windows. Use the window lock switch to help pr ...
Moonroof
Basic information
WARNING
In an accident you could be thrown from the vehicle through an open moonroof. Always wear seat belts and use proper child restraints when driving the Nissan Rogue.
Do not ...
Other materials:
Wiring diagram
BCM
Wiring Diagram
...
Front wiper motor HI circuit
Component Function Check
1.CHECK FRONT WIPER HI OPERATION
CONSULT ACTIVE TEST
Select FR WIPER of BCM (WIPER) active test item.
Check front wiper operation.
HI : Front wiper (HI) operation
OFF : Front wiper OFF
Is the inspection result normal?
YES >> Front wiper motor ...
B2267 engine speed
Description
The engine speed signal is transmitted from ECM to the combination meter with
CAN communication.
DTC Logic
DTC DETECTION LOGIC
DTC
CONSULT
Detection Condition
Possible Cause
B2267
TACHO METER
[B2267]
ECM continuously transmits abnor ...
